Elsema iS2000 Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Открыватель ворот Elsema iS2000. Elsema iS2000 8 страниц. High speed sliding gate
opener
elsema’s eclipse
control card with gds operator
Также для Elsema iS2000: Руководство пользователя (7 страниц)
Печатать страницуQuick Start Instructions
1. Place operator in correct position (Pinion wheel to be parallel to the gate and stepped out
to allow for width of rack once it is mounted onto the gate frame). Mark out fixings and fix
operator to the concrete pad.
2. Fix rack to the gate frame keeping 1mm-2mm clearance between the rack teeth and Pinion
wheel.
3. Once the rack is fixed move the gate and sight the rack moving over the pinion wheel,
check that most of the pinion wheel meshes with the rack. Make sure rack runs freely over
the pinion wheel, any tights spots should be corrected by adjusting the rack height. Check
the operator is firmly bolted down to the concrete pad.
4. Ensure stops are installed on the gate for the fully closed and fully open positions.
Connect Photo Electric Beams, Safety Bump Strip and all other safety devices as required.
Limit Switch Adjustment
Elsema's Industrial motor kits are equipped with dual limit sensors. The 1
and the 2
nd
limit stops the gate. The stop limit in one direction becomes the slow limit in the
opposite direction automatically.
Move the gate into full close position and adjust the magnet on the gate so it aligns with the Stop
limit in the closing direction.
Move the gate into fully open position and adjust the magnet on the gate so it aligns with the Stop
limit in the opening direction.
st
limit slows the gate
5