Dust Free BIO-FIGHTER 4Xtreme Руководство по установке и эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Осветительное оборудование Dust Free BIO-FIGHTER 4Xtreme. Dust Free BIO-FIGHTER 4Xtreme 9 страниц. 21", 33", 45" ultraviolet light systems

Печатать страницу

BIO-FIGHTER® 4XTREME INSTALLATION & OPERATION MANUAL

IMPORTANT:

The device must be installed in compliance

with all national and local electrical and

mechanical codes. Failure to do so will void

Dust Free® warranty.

CONDUIT INSTALLATION

Remove the two cover retaining screws and

swing open the cover to access ballast and

wiring. Install an appropriate weatherproof

conduit on the side of the enclosure. Drill

points are marked on two sides of the enclo-

sure where it is safe for conduit installation.

Connect the electrical service, through the

conduit, to the ballast wires. Connect the black

and white wires to power and the green wire to

ground. Refer to Fig. 5 for wiring diagram.

Fig. 4 Install weatherproof electrical conduits at either of the loca-

tions marked by dimples on the outside of the enclosure.

Ballast

Fig. 5 Wiring diagram.

WARNING

Electrical shock hazard.

Can cause injury or death. Before perform-

ing any service or maintenance disconnect

electrical service to the unit.

(Fig.4 )

Conduit installa-

tion points indi-

cated by dimples

on outside of

enclosure.

Black Wire

To 120V - 240V

White Wire

Electrical Service

Green Wire

To Ground

TILT-LAMP INSTALLATION

To maximize the efficiency and life of the UV-C

lamp, clean each lamp prior to installation.

Use isopropyl alcohol and cotton cloth to wipe

dust and fingerprints from the lamp.

Gently insert the lamp into the lamp hole.

While holding the lower slide bracket under

the retaining lip of the lamp, push the upper

slide bracket over the retaining lip of the lamp

and tighten the two knurled nuts until the lamp

is securely fastened.

Lamp retaining lip

Lower slide bracket

Lamp retaining lip

Important: O-ring

must be between slide

brackets to prevent

damage to ceramic

lamp base.

Fig. 6 Hold lower slide bracket in place under lamp retaining lip

while pushing upper slide bracket over lamp retaining lip. Secure

with two knurled nuts.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent

loss of vision, and sunburn. Take precautions

to protect eyes and skin from direct exposure.

WARNING

Mercury Hazard. Do Not Break.

Each UV-C lamp contains a small amount of

Mercury. May cause redness or irritation. Use

proper disposal techniques in case of breakage.

(Fig.6 )

Upper slide bracket

Lower slide bracket