elsner elektronik RF-MSG-ST IP53 Технические характеристики и инструкции по установке - Страница 2
Просмотреть онлайн или скачать pdf Технические характеристики и инструкции по установке для Блок управления elsner elektronik RF-MSG-ST IP53. elsner elektronik RF-MSG-ST IP53 2 страницы. Radio motor control unit
Печатать страницу
Fig. 3
Input mains voltage
STAS3 slot for
STAK3 coupling
PE
1 Neutral conductor
2 L
3 nc (not connected)
PE
2.4. Establish wireless connection
1. Set the control unit and/or remote control or the button to teaching mode (obser-
ve the corresponding manual/data sheet)
2. Switch on the RF-MSG-ST IP53 voltage supply or interrupt it for at least 3 se-
conds if the unit is already supplied with power.
3. For 5 minutes after connecting the voltage, the RF-MSG-ST IP53 will send a "Le-
arn" telegram every 10 seconds.
4. The wireless connection will be established automatically. For building control
systems, the display will display "Device is learning".
5. The RF-MSG-ST IP53 will stop sending "Learn" telegrams once the reply "Lear-
ned" (for a learning process) or a control command is received (in the event of a
power interruption during operation).
2.5. Notes on mounting and commissioning
Device must not be exposed to water (rain). This could result in the electronics being
damaged. A relative air humidity of 95% must not be exceeded. Avoid condensati-
on.
3.
Disposal
After use, the device must be disposed of or recycled in accordance with the legal
regulations. Do not dispose of it with the household waste!
Radio motor control unit RF-MSG-ST IP53 • Version: 08.06.2020 • Technical changes and errors excepted. • Elsner Elektronik GmbH • Sohlengrund 16 • 75395 Ostelsheim • Germany • www.elsner-elektronik.de • Technical Service: +49 (0) 7033 / 30945-250
Radio motor control unit RF-MSG-ST IP53
Motor output
STAK3 coupling for
STAS3 plug
PE
1 Neutral conductor
2 Up
3 Down
PE
2