Datalogic QLM500 Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Считыватель штрих-кодов Datalogic QLM500. Datalogic QLM500 17 страниц.

DESCRIPTION

The QLM500 EtherNet/IP Gateway is an active connection module which can be used in

Standalone or ID-NET™ Master Multidata, or Master Synchronized layouts. It provides a fast

and efficient way to cable both an EtherNet/IP network and an ID-NET™ network using

standard cables.

It provides separate M12 connectors for Power Supply, Ethernet Communication, ID-NET™

Network, External Trigger, Digital I/O and Aux RS232 Communication for configuration of the

reading device.

The QLM500 Gateway provides an easy way to connect many Datalogic reading devices to

any PLC with EtherNet/IP support. It allows EtherNet/IP real-time communication with bus or

ring topologies, and due to its two Ethernet ports, it eliminates the need for expensive

external switches.

Host communication is provided through the integrated EtherNet/IP circuitry which connects

internally to the reader's Main serial interface (RS232).

ID-NET™ network and power supply signals are provided to the next connected device (ID-

NET™ Slave), by means of a dedicated M12 connector. However there is not a second

ID-NET™ network connector for bus propagation and therefore the QLM500 cannot be used

as an ID-NET™ Slave.

The reading device is connected to the QLM500 through a standard 25-pin D-sub connector.

Three rotary switches allow easy manual Network Addressing selection.

The following accessories make system cabling easy:



CBL-1487 connector or CS-A2-02-G-xx cable, to build the Power Supply connection.



FMC600 connector, to build the I/O connections.



CAB-AUX03 cable, to connect the Gateway to a PC to configure the connected reading

device.



CBL-1480-xx cable, to build the ID-NET network connections.

If necessary, commercial cables are available for trigger connections to a PNP photocell (see

TRG Connector paragraph).

QLM500 has integrated on-board backup memory and therefore supports Backup and

Restore procedures for the connected device and relative ID-NET™ network (if used). See

the device's Backup and Restore procedure in the Help On Line.

For the 2KN-4K Family Scanners, Backup and Restore can also be performed using

programming barcodes, see the Setup Procedure Using Programming Barcodes document

on the reader's CD-ROM.

For full compatibility with QLM500, the 2KN-4K Family Scanner must have

software package 007_3 or later.

NOTE

QLM500 INSTALLATION MANUAL