Dataman Cipher 1660 BT Portable Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Считыватель штрих-кодов Dataman Cipher 1660 BT Portable. Dataman Cipher 1660 BT Portable 9 страниц. Ccd scanners
Печатать страницуDelete the last collected data when operating in remote collection (memory) mode...
Press the Power/Delete key. The scanner will respond with two short beeps (high tone), the
LED will illuminate solid red for a period of 1 second. During this period of time and before the
illuminated LED turns off press the Power/Delete again to confirm the deletion.
CONNECTION WITH CIPHER 3610 USB BLUETOOTH TRANSPONDER
Windows:- Connect the Cipher 3610 Bluetooth transponder to a vacant USB port on your
computer, the host computer may respond with a pop up text balloon in the bottom right of the
screen indicating "NEW USB Hardware found".
In some cases where the 1660 BT has been programmatically reconfigured it may be
necessary to re-pair (bind) the 1660 BT unit with the 3610 transponder.
Pairing (sometimes referred to as binding) is the process of respectively scanning both the
"Set Connection" bar code and the "Serial No" bar code located on the 3610 transponder
unit using the associated 1660 scanner unit, a rapidly flashing blue light on the transponder
will indicate successful pairing.
TIP:- Because above bar codes are close together cover unwanted barcode while scanning.
The bar code reader is now ready to use, simply open the application that you require to
capture the bar code data and start scanning. For Windows users an ideal application to test
the scanner is "Notepad", a small editor program located among Windows accessories.
How to scan with the Cipher 1660 BT Scanner:
•
Hold the 1660 Scanner at an angle to the bar code
•
Position the 1660 Scanner between 8 – 18 cm from the bar code and press the scan key
•
Scan beam must extend at least 1 cm beyond edges of bar code
•
Slowly bring the 1660 closer to the bar code until a good read beep is achieved
Second, let's review how to deal with worn, damaged or covered bar codes:
Many times, the bar code may be ripped, faded of poor quality or has been covered with a
clear protective overlay. If a bar code does not immediately scan then slowly move the
scan beam from the top of the bar code to the bottom. This gives the scanner a better
chance to find "good spots" within the bar code, if the protective overlay is not completely
flat or clear and gives off false reflections then permanent errors and the total inability to
read the bar code underneath can result. In cases like this the solution lies with replacing
the covered bar code and not with the bar code reader.
approximately
10 – 15 degrees