DUUN TF240 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Снегоуборщик DUUN TF240. DUUN TF240 17 страниц.
5
Power transmission shaft
The tractor is disengaged and the handbrake is applied
before the shaft is connected to the tractor's PTO.
The maximum power output speed is 540 rpm. The drive
shafts are always to be equipped with original protection
covers.
Damaged and worn covers are to be replaced
immediately!
Make sure that all covers for the shaft are in good
condition and correctly fitted. Never start the machine
when this is not in order. The locking chains for the
plastic covers are always to be fixed to the appropriate
brackets in order to prevent the covers to rotate. The
covers must be lubricated according to the specified
interval.
Rotating parts – high risk of injury
The rotating parts of the machine can cause major
damage to body parts that come into contact with them.
Do not allow anybody to stay in the work area when a
machine is in operation.
Hydraulic high fluid pressure
Be careful when you work with hydraulics. Wear eye
protection and gloves. Hydraulic oil under high pressure
may penetrate the skin and cause serious infections.
See a doctor if you have sustained an injury. Make sure
no one is close by when performing hydraulic functions.
Rotating parts – risk of crushing
Case covers and moving parts are preferably marked in
yellow.
All covers must always be used except when necessary
maintenance, and always with a stopped engine as
mentioned in safety in case of interruptions and
maintenance. Pay special attention to clamping risk at
points marked for this. Avoid hydraulic movement of the
ejection spout when there are people nearby.
Never drive with open covers for chains and sprockets.
Chains and sprockets can cause major damage to body
parts that come into contact with them during operation.
Clamping risk when adjusting
When adjusting the support wheels, make sure that you
do not stand with your feet under the wear steel.