Dataprobe IP-410 - Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Переключатель Dataprobe IP-410 -. Dataprobe IP-410 - 17 страниц. Web controlled power switches

iPAL
Operating Mode
The iPAL supports seven operating modes, which determine how information is displayed, how the inputs are used and how
the LED indicators operate. The following chart details each Operating mode.
Mode
1 Generic I/O
2 Control w/ Feedback
3 A/B No Feedback
4 A/B w/ Feedback
5 Power No Feedback
6 Power Bi-State Fbk
7 Power Tri-State Fbk
Password
This selection offers an opportunity to change the password required for Telnet and Web Browser Access. To change the
password, Select 4 from the Setup Menu. The password can be up to 8 characters and is case sensitive. Please remember
your password. If you forget your password the unit needs to be returned to Dataprobe or an Authorized Service Agent for
reset.
Pulse Time
This feature selects the time in seconds for a Pulse command for any of the relay circuits. This would typically be used to
support power-off-reset for power control applications. To set the cycle time, select 5 from the Setup Menu. The Pulse Time
can be from 01 to 99 seconds. Use Leading zeros when entering 01 to 09 seconds.
Web Page Refresh Time
When using Mode 1, with independent inputs, an automatic refresh rate for Web browser status updates can be set. This will
cause the iPAL to re-read the inputs and report the status. To set the Web Page Refresh Time, select 6 from the Setup
Menu. Times of 00 (no refresh) to 99 are accepted.
* Std. Default = 6 *
Relay De-
Energized
Reported
As:
Off
Off
A
A
On
On
On
* For All Models *
* For All Models *
* Std Default * = 10
Relay
Energized
LED On when
Reported
Relay:
As:
On
Energized
On
Energized
B
Energized
B
Energized
Off
De-Energized
Off
De-Energized
Off
De-Energized
Page 11
Input Circuit
Operation
Independent Inputs
Feedback Monitor
Not used
Feedback Monitor
Not Used
Feedback Monitor
Feedback Monitor