AGRI-COVER VANISH Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары AGRI-COVER VANISH. AGRI-COVER VANISH 17 страниц. Roll-up cover
Печатать страницу
5: INITIAL OPERATION AND ADJUSTMENTS
A. Unroll cover and place rear bar into
strikes on side rails. Press down on rear
bar to close (20-30 lbs pressure). The
cover fabric may be tight. Over time, under
tension, it will conform to its hardware and
loosen slightly. If rear bar is too hard to push
down, adjust tensioners equally as needed
to close.
NOTE: If cover is too tight, it may impact
latching mechanism.
B. Close tailgate slowly, top of tailgate
should fit snug under rear bar. If cover
impedes normal tailgate operation, raise
side rails by: loosening rear clamps,
adjusting side rail up and then tightening
clamps. If there is a gap between tailgate
and cover, adjust side rails lower.
IMPORTANT: Verify each clamp is
torqued to 20 ft-lbs or value specified in
special instructions (if supplied). Start
behind cab and work toward tailgate.
C. Check cover tension by releasing latch
and then opening and closing rear bar
several times. It should snap when closing.
Cover fabric should be tight without sagging
between the bows.
D. If adjustment is needed, roll cover open
then either: turn tension adjuster clockwise
to loosen or turn tension adjuster counter
clockwise to tighten. Ensure to adjust
tensioners equally.
E. Always seal both sides of cover with hook
and loop system. For detailed operating
instructions see pages 12 and 13.
Tip: Reasons to keep cover tight:
1. Increases longevity
2. Decreases noise
3. Enhances appearance
10
Strike at rear
To Loosen Cover
Turn Clockwise
To Tighten Cover
Turn Counter
Clockwise