4ms Company Row Power 25 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Источник питания 4ms Company Row Power 25. 4ms Company Row Power 25 4 страницы. Power supply module for the eurorack modular system

Печатать страницу

Bus Board (4ms Bus Stick or other passive distribution board)

Row Power 25

Any passive power distribution board can be used with the

. If the bus board connects

to the power supply with a standard 16-pin Eurorack power cable, then simply use the male pin power

Row Power 25

connector on the back of the

to connect to the bus board. Verify the red stripe is

pointed down on both ends of the cable. An example using the 4ms Bus Stick is shown below.

The Bus Stick can be secured to the case using the adhesive pads on the back. Make sure the surface

is clean and apply pressure for 20 seconds. It's safe to daisy-chain a flying bus cable or another Bus

Stick, but to insure the lowest noise system, use as few connectors as possible.

Solder connectors

Row Power 25

The

has a set of four holes for +12V, -12V, +5V, and ground. The holes are

0.082" (2.1mm) in diameter and are spaced 0.156" (3.96mm). They fit the Molex MTA156 connector

(example: Molex PN: 5273-04A or 09652048). They also will fit 14 AWG wire.

These connectors are provided for advanced users with sufficient knowledge of soldering and power

systems. They can be used with a custom or specialized low-noise bus board system. While 4ms

Row Power 25

Company will warranty and support the internal circuitry of the

, we do not offer

support for 3rd party or DIY bus boards or distribution systems.

Page