Aussie Vantage 2200 Руководство по сборке и эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для гриль Aussie Vantage 2200. Aussie Vantage 2200 16 страниц. Portable lp gas grill
Также для Aussie Vantage 2200: Руководство по сборке и эксплуатации (16 страниц)

Aussie Vantage 2200 Руководство по сборке и эксплуатации
Use only 1 lb. propane cylinders or 20 lb. propane
cylinders with proper adaptor hose as specified above.
Use of other gas cylinders could cause gas leak or fire.
· Read manufacturer's instructions and warnings on LP
cylinder.
· Never use an LP gas cylinder if it shows signs of: dents,
gouges, bulges, fire damage, corrosion, leakage,
excessive rust or other forms of visual external damage;
it may be hazardous and should be checked by a liquid
propane supplier.
· Keep children away from LP gas cylinder at all times.
· Do not use, store, or transport the LP gas cylinder where
it would be exposed to heat, sparks or flame. The relief
valve may open which will allow a large amount of
flammable gas to escape. Never leave an LP gas
cylinder inside a vehicle which may become overheated
by the sun.
· WARNING! Never store an LP cylinder indoors.
Storage of an outdoor cooking gas appliance indoors is
permissible only if the cylinder is disconnected and
removed from the outdoor cooking gas appliance. LP
Cylinders must be stored outdoors out of the reach of
children and must not be stored in a building, garage, or
any other enclosed area.
· WARNING! Never store a spare LP gas cylinder
near the grill. All spare and disconnected LP gas
cylinders must have safety caps installed.
· LP gas is not natural gas. The conversion or attempted
use of natural gas in an LP unit or LP gas in a natural
gas unit is dangerous and will void your warranty.
· WARNING! Never attempt to repair or refill a 1 lb LP
gas cylinder valve. Repairing or refilling could cause a
hazard or explosion. Replace gas cylinder with a spare.
· Using a repaired or refilled 1lb. LP Gas Cylinder will void
the warranty.
· When transporting an LP gas cylinder, keep it secured
in an upright position with the protective cap on.
Connecting/ Disconnecting LP
Gas Cylinder to Grill
· Always check for gas leaks when you disconnect
and reconnect the regulator to the LP gas cylinder,
especially after a period of storage (for example, over
winter).
· Check tubes leading into the burner for blockage from
insects, spiders, or food grease before using.
· Check Regulator Hose or other supply hoses for
cracking, brittleness, holes, or leaks. Make sure there
are no sharp bends in the hose.
· Make sure Regulator Hose does not contact hot metal
surfaces.
REGULATOR ASSEMBLY
· Using a hose and regulator assembly that has not
been supplied by the manufacturer of this LP gas
grill, could result in serious bodily injury or property
loss.
· Use only the hose and regulator assembly that has been
furnished with this LP gas grill. If the hose and regulator
assembly is not working properly and you need a
replacement, contact the manufacturer (1-800-251-7558).
· Inspect the hose before each use. If the hose is cut or
damaged or shows signs of excessive abrasion or wear,
do not use the LP gas grill. Contact the manufacturer, as
the hose must be replaced with an assembly specified by
the manufacturer prior to the further use of the LP gas
grill.
Preparation Before Cooking
· Wash the Cooking Surfaces with a mixture of hot water
and dish detergent. Do not use an abrasive scrubber. This
product is non-stick coated and harsh cleansers will ruin
the finish. Be sure to re-install the Ribbed Cooking
Surface with the grease drain toward the rear over the
grease cup.
· Empty the Grease Cup after each cooking session so
excessive grease does not accumulate. Do not jerk the
grease cup out with grease in it. (See FIG. 19) Wash
Grease Cup same as Cooking Surfaces.
· Make sure Grease Cup is in place before each grilling
session. (FIG. 19)
· Empty the Grease Cup after each cooking session
so excessive grease does not accumulate. Failure to
remove grease may result in a grease fire in the Cup
or Bowl.
· Allow grill and grease in Grease cup to cool before
emtying Grease Cup.
· Never light the LP gas grill without the Grease Cup
in place.
Use Clean
and Empty
Grease Cup
before each
grill session.
Install and remove with steady pressure to
snap into grill body. To avoid spillage, do not
jerk grease cup with grease in the cup.
8
FIG. 19