4O3A Rotator Genius Руководство - Страница 15
Просмотреть онлайн или скачать pdf Руководство для Контроллер 4O3A Rotator Genius. 4O3A Rotator Genius 20 страниц.
4.2 Recalibrating the sensor
Sensors are carefully calibrated in the factory. If the sensor is showing bad
azimuth values try using the sensor correction algorithm first. (chapter 4.1)
The only time you would need to do this is if we don't calibrate a sensor at
all by mistake.
A symptom for this is a sensor that shows a fixed value constantly no matter
where you point it at.
So please do not attempt to do this unless you are absolutely sure it is
necessary – all factory calibration data will be lost permanently.
Calibration requirements:
The sensor should be attached to the boom in the same way it is going to
be used.
1.
Your boom must be able to make full 360 degree turns.
2.
The more full rotations you can make the higher the precision will
be. Around five rotations is considered is optimal.
3.
You can rotate in any direction, CW, CCW or mixed. Main point is
letting the sensor sense all 360 points.
The slower you rotate while calibrating the higher the precision will
4.
be in the end.
Calibration process:
1.
In order to start the calibration process you need to disconnect the
sensor from the device, and open the casing.
2.
Set PIN 1 and PIN 6 to ON, as shown on the picture. Do NOT use a
metal screwdriver for this because it will mess up the readings.
Connect the sensor back to Rotator Genius.
3.
4.
There will be no reading on the LCD display or Panel Application
during the calibration mode.
Make five full rotations in any direction, back and forth, one way,
5.
doesn't matter.
6.
When done, set PIN 1 and PIN 6 to OFF.
7.
The sensor should now be calibrated. You will see a reading on
your LCD display and Panel Application.
8. Repeat the process if not satisfied with the results.
When done seal the sensor box.
9.
5. Control software
5.1 Windows App
Download and install the latest Panel and firmware software from
The app is designed Windows 7, Windows 8 and Windows 10. It can be used on a Windows tablet and phone as well.
Follow the setup. Rotator Genius icon will appear on your desktop.
⬆
Back to table of contents
http://4o3a.com/index.php/downloads
Calibration pins
Page 15