Aussie Pumps BB100 Hire Series Руководство по эксплуатации и техническому обслуживанию - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Мойка высокого давления Aussie Pumps BB100 Hire Series. Aussie Pumps BB100 Hire Series 16 страниц. High pressure blasters
Печатать страницу
Aussie Pumps
CARE & MAINTENANCE:
AFTER EACH USE
If there is a danger of freezing anti-freeze should be mixed with the flush water or the machine must
be completely drained.
After the final flush stop the machine. DO NOT allow the machine to idle for more than 15 seconds.
This is particularly important when there is a danger of freezing. Do not run for longer without water
supply.
STORAGE
Store the washer in an upright position, preferably drained of water if there is a danger of freezing (or
fill with anti-freeze).
PUMP CRANKCASE LUBRICATION
Proper pressure washer pump crankcase lubrication will help extend the working life of the machine.
Follow these important guidelines. We recommend keeping a simple service log book.
Change oil in pump after initial 50 hour run-in period. (SAE 75W-90)
Change pump oil every 3 months, use high quality oil. (SAE 75W-90)
Pump oil level can be checked with the dip stick under the breather cap or by viewing the oil
sight gauge where fitted. The oil level is correct if level is in the centre of the gauge. If oil level is
low, fill to correct level with recommended oil (SAE 75W-90). DO NOT OVERFILL
CRANKCASE!
Replace oil in gearbox (separate chamber) with SAE 90 gear oil every three months.
PREVENTATIVE MAINTENANCE
Keep filter in supply hose connection clean, rinse regularly.
Use correct size nozzles for machine and replace when worn, check serial tag for correct size.
Drain water from pressure hoses, gun/lance assembly and accessories after use.
Protect pump from freezing. Failure to remove water from the pump in freezing temperatures will
result in damaged pump manifold.
Use ONLY injector of the size and type designed for this model.
DO NOT tamper with unloader valve adjustment or alter engine or motor speed.
DO NOT siphon chemicals through the pump, it is designed for water only.
Incoming water supply must not exceed 60ºC, otherwise pumps seal damage could result
Follow engine manufactures guidelines for engine maintenance. (see engine manual)
Look after your machine &
8
it will look after you!
Aussie BB Hire Series ... Operation & Maintenance Manual
June 2016