DVDO DVDO-Xtend-TX100 Руководство пользователя - Страница 17
Просмотреть онлайн или скачать pdf Руководство пользователя для Передатчик DVDO DVDO-Xtend-TX100. DVDO DVDO-Xtend-TX100 19 страниц. 3 x 1 hdbt wall-plate transmitter
Печатать страницуDVDO
"DVDO Product Configuration Tool" menus are described below:
•
Get current settings: Get the current settings of the sink device.
•
Baud rate: Choose the correct baud rate according to the device, then click
"Connect" to connect with the sink device.
Note: This might be different than the setting of 115200 above and is
determined by the sink device you are connecting to.
Power on: Pre-load and store the command for "power on" to a sink device,
•
then click "Send" to send and store it on the device.
•
Power off: Pre-load and store the command for "power off" to a sink device,
then click "Send" to send and store it on the device.
Note: If the sink device requires hex commands, make sure the Hex box is
checked.
Delay: Set delay time (1~30minutes) the sink device will power off
•
automatically after it cannot detect the input signal, click "set" to take effect.
•
Set Terminator: Select the command ending after each API command that
you are sending from the transmitter or receiver to the sink device. Then
click "Set" to take effect.
•
Set Relay Mode: Set relay mode for the sink device.
Latch –relay closes and latches when it is triggered;
Momentary –only closes for a moment and then opens after it is triggered.
The pulse time can be set from 1 to 10 seconds, default setting is 3s.
Then click "Set" to take effect.
DVDO-Xtend-TX100 3 x 1 HDBT Wall-plate Transmitter User Manual
17
DVDO-Xtend-TX100_V1.0.0