ADE M600020 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Весы ADE M600020. ADE M600020 16 страниц. Electronic bed scale

5. Place the patient into the bed. The displayed weight is the weight of the patient.

6. If the weight of the patient should be ignored as well (e.g. for dialysis purposes), follow the instruction

under the point "Tare function".

7. If the weight of the bed including bed-clothes is already being stored follow the instruction under the

point "Restore the preset tara value"

Weighing

Press the ON key for at least 3 seconds to turn the scales on. An automatic function test will be conducted

afterwards. The test is done when the display shows zero. The scale is now ready for the weighing procedure.

Resetting the scales back to zero: Wait until the standstill status indicator

ZERO key (8), measuring inaccuracies after switching on the scale are being compensated. The zero key

restarts the scale. The status indicator (6)

The TARE key (9) is useful for many weighing operations. Tare might be useful in case the patient is being

place on the scale/bed with items (e.g. clothing, bed clothing shoes or other items) which should be ignored by

the scale. Weigh these items first. After the weight is displayed, press the TARE key (9) to reset the display

back to zero. The display changes to net mode (NET status indicator (5) is on) and shows zero.

Note: Taring the bed with subsequent determination of the patient weight is not possible/practical, as the bed

weight is subtracted from the maximum load of the scale and thus only a small weighing range is avail-

able. To determine the patient weight, proceed according to section "Before Weighing" on page 7.

Entering manually tare - values

The user is able to insert manually the gross weight, which is for example mentioned at the identification plate

of the bed. Enter the appropriate tare value just by using the key pad under normal weighing mode. The value

will be stored after use of the ENTER key (or TARE). The ADE-display is now ready for weighing and changes

to net mode [NET status indicator (5) is on]. Enter the tare button to leave this mode.

Preset tara

Press and hold the PRESET TARE key (10) for approx. 3 seconds. PRO PT X appears on the display. Select

the memory location 1-10. Now enter the TARE VALUE which you would like to be ignored by the scale and

confirm same with ENTER. The value is displayed as a negative figure and will be deducted when a load is

being placed on the scale. Enter the on/off, zero – button (8) to leave this mode.

Restore the preset tara value

Press the PRESET TARE key (10). "Pt x" appears on the display. Enter a number from 0-9 (memory location

for the tare value). If no new number will be inserted to change the already displayed value within five sec-

onds, the unit will turn back to weighing mode and displays the last stored value as negative figure as above.

Enter the on/off, zero – button (8) to leave this mode.

Displaying the gross weight, net weight and tare value

Press the "0" key to change between the net weight (gross weight minus the tared value) and the gross

weight.

The determined weight could be continued being displayed even when the load has already been removed.

That enables taking care of the patient first before reading the results.

To use the hold function the scale must be at standstill. The standstill status indicator

Hold appears at the digital display. Deactivate the HOLD function by pressing the key again.

appears when the scale is being resetted.

(14) appears. By entering the

(14) is on and

M600020-210322-Rev008-UM-e