DVS G3 Мануалы по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Мануалы по эксплуатации для Вентилятор DVS G3. DVS G3 10 страниц. Small inline filter
Также для DVS G3: Руководство по эксплуатации (3 страниц), Инструкции по монтажу (2 страниц)

Changing Airflow

The AIRFLOW menu enables you to adjust and fine-tune the airflow level higher or lower than the

pre-set calibrated level (represented by the '0' setting).

Using the Up and DOWN Fan Controls

In MAIN MENU 1 press AIRFLOW to open the AIRFLOW MENU. To change airflow, press the UP or

DOWN arrows on the right hand side of the screen.

The AIR FLOW setting of '0' is the calibrated and recommended level of airflow for your home.

NOTE:

Increasing Airflow

You may wish to increase airflow in order to allow for a temporary increase in the number of

people living in your home, or to improve the extraction of stale air or moist air, for example

from your bathroom(s) – although FAN BOOST is the primary means to achieve the latter, see

below.

You can experiment using this feature, but if you consider a permanent increase or decrease in

the fan speeds is necessary, please contact DVS on 0800 387 387.

Using Fan Boost

FAN BOOST changes the airflow to double the normal calibrated speed for a selected period of time.

Once the timer has expired the airflow will revert to the speed determined by the AIRFLOW menu and

the calibrated setting for your home. Pressing FAN BOOST cycles through 1/2HR, 1HR, 11/2HR or

2HR and OFF).

This option is useful for when you are taking a shower as it will enable the bathroom to be cleared

more quickly of the extra moisture created.

Changing Seasons

Changing Between Seasons

To change between SUMMER and WINTER touch the word shown on the Current Status Screen.

This automatically changes between Summer and Winter.

The only change that this makes to the system is to the logic within the algorithm used to determine

when the exhaust air stream fan is switched off. There will be circumstances when it is detrimental to

have the exhaust air passing through the exchange core and transferring its warmth to the incoming

supply air. The circumstances change from SUMMER to WINTER so it is important to change from

one season to the other at the appropriate time. When in SUMMER this will be when the incoming air

temperature is above that set. If in WINTER it will be when the incoming air temperature is below that

set.

Please do not hesitate to call our service staff on 0800 387 387 if you need help.

Resetting or Changing the Clock

As mentioned previously, a power interruption will cause the CLOCK to lose its settings. All other G3

Reclaim settings including any pre-set TIMER settings will be saved during a power interruption.

However, any TIMER settings will be inactive until the CLOCK has been reset.

The Clock will also need to be changed at the start and end of daylight savings.

Setting the Clock

It is important to check and set the CLOCK correctly as all TIMER settings rely on the correct day and time

being programmed.

Press the day/time figures on the Current Status screen or press the MENU and MORE buttons to

bring up the MAIN MENU 2 screen. Select SYSTEM menu and then press SET CLOCK.