Austin Kontore Leopold Bench Kit Руководство по сборке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по сборке для Хранение инструментов Austin Kontore Leopold Bench Kit. Austin Kontore Leopold Bench Kit 12 страниц. Children's version

Печатать страницу

Attaching The Seat

(2) Leg Assemblies

(Assembled previously)

(1) 28" 2x8 Pine

Straight 90° cuts

Seat

(8) 2 ½" Screws

Exterior Wood Glue

Now that the Leg units are assembled, the seat will be installed. It is important that the seat be carefully

fastened so that the legs are perpindicular to the floor (standing plumb – straight upright).

A helper can assist in holding the piece tightly while you are drilling and screwing it together, and a level

can help make sure everything is plumb and level.

Stand the Leg Assemblies up. They should be spaced 28"

apart.

Note: A helper is useful here.

While the legs are standing up, spread a little glue on the

tops of the Rear Legs.

Important: Construction adhesive does not stain, and

can be difficult to sand off. Try to avoid getting any on the

face (exposed surfaces) of the wood. Clean up excess right

away.

Lay the seat in place, on top of the glue.

Important: Before putting the seat in place, check to

see which side is most attractive. Have the nicer side

facing up. This is a good way to "hide" knots in the wood.

Don't worry about lumber grade marks—those can be

sanded off.

REPEAT for both leg assemblies.

Page 8 of 12