Austlift 915220 Инструкции пользователя - Страница 6

Просмотреть онлайн или скачать pdf Инструкции пользователя для Подъемные системы Austlift 915220. Austlift 915220 12 страниц. Retractable fall arrester

Печатать страницу

• It is advisable to use the dorsal attachment D-Ring of the harness for connection to the

Retractable Fall Arrester.

• However if it is not possible for any reason, the chest attachment element may also be used.

• It is essential to verify that a minimum 4ms height of free space is available below the user's

feet & the ground level at the work place, so that in case of a fall, there will be no collision with

the ground or other obstacle in the fall path.

• Following conditions may be hazardous & may affect the performance of Retractable Fall

Arrester:

(a) Extreme temperature

(b) Trailing or looping of Lanyards over sharp edges.

(d) Abrasive or sharp edged structures which can damage the equipment.

(e) Pendulum falls.

• Ensure that manufacturer's packing is used during transportation to prevent damage. In case

original packing in not available, use polybag which is sealed to prevent moisture.

• It is essential for the safety of the user that if the product is resold outside the original country

of destination, the reseller shall provide instruction for use, for maintenance, for periodic

examination and for repair in the language of the country is which product in to be used.

• This is advised that Annual inspection should be done by competent person & if any discrepancy

is found in product, service will be done at authorized service center only.

ADDITIONAL INFORMATION AS PER VG 11

• It is possible to use a horizontal retractable type fall arrester over an edge type A (Sharp Edge

Units)

• It is recommended to avoid the loading of the retractable type fall arrester over edges.

• The retractable type fall arrester marked with edge symbol was also tested also for horizontal

use and a drop over a Type A edge has been successfully tested.(Sharp Edge Approved)

• Type A edge definition: A steel edge with a radius of r = 0.5 mm and without burrs was used

for the test. Due to this test, the equipment may be used over similar edges, as can be found

e.g. at rolled steel profiles, at wooden beams or at a clad, rounded roof parapet. However,

the following shall be considered when the equipment is used in a horizontal or transverse

arrangement and a risk of a fall from a height over an edge exists:

1. If the risk assessment carried out before the start of the work shows that the edge is very

"cutting" and / or "free of burrs" (such as in case of an unclad roof parapet, a rusty steel girder

or a concrete edge)

- relevant measures shall be taken before the start of the work to prevent a drop over the edge

or, before the start of work, an edge protection shall be mounted or

- the manufacturer shall be contacted.

2. The anchor point should only be situated at the same height as the edge at which a fall might

occur or above the edge.

915207