Austral Lock ELEGANCE Иллюстрированные инструкции по монтажу

Просмотреть онлайн или скачать pdf Иллюстрированные инструкции по монтажу для По замкам Austral Lock ELEGANCE. Austral Lock ELEGANCE 2 страницы. Highed security doors

Печатать страницу

ELEGANCE

for hinged security doors

Austral

Illustrated fitting instructions

Lock

ILLUSTRATED FITTING INSTRUCTIONS

156mm

16mm

Door Cutout

Lockbody Installation

Insert the lock body into the door cutout

Secure the lockbody with the two

#8x13mm lockbody screws.

Note: If NOT using the 'Caretaker' feature - go to Step 6.

Select the exterior handle assembly which includes the

caretaker mechanism shown below.

When viewing the door from the outside of the house,

if the hinges are on the right hand side, rotate the 'D' pin towards the

right hand marks - RH. As shown below.

If the door hinges are on the left hand side, rotate the 'D' pin

towards the left hand marks - LH. As shown below.

'D' pin shown

rotated for

Right Hand

door

If not using the 'caretaker' feature, push the plastic plug which

has the Austral logo, into the square hole shown below.

Move the 'D' pin until the Austral logo on the plastic plug is vertical.

After adjusting, give the plug a final push to insure it is tight.

square hole

plastic plug with

Austral logo

door cutout

lock body

screw

'Caretaker' feature

Caretaker

mechanism

'D' pin shown

rotated for

Left Hand

'Caretaker' feature

The sticker on the rear of the lockbody

is to assist in easy installation. - Do not

remove.

If the sticker has been broken or removed,

ensure that the rear slide is pushed

completely down before assembling the

lockbody into the door cutout.

IMPORTANT : If installing ELEGANCE with a multipoint

accessory kit, be sure to follow the cylinder installation

procedure within the multipoint kit instructions.

Depress the auxiliary bolt to ensure the

main bolt is fully extended.

Assemble the cylinder through the lock

so the cylinder protrudes equally from

both sides.

NOTE : the cylinder cam must rotate as

shown below. (cam turns towards front

of door)

Insert the key and turn to locked position.

Insert #10 x 38mm cylinder screw & tighten.

NOTE : test, main bolt should not depress

Turn key to unlocked position and

remove key.

Slide the Caretaker spindle

vertically under the

caretaker cover

plate as shown

below.

Go to step 7

door

Select the interior handle assembly with snib lever hole.

Select the correct snib lever as shown in the box below.

Hold the snib lever horizontally and insert it into

the snib lever hole, turn it until vertical to secure it.

If the handle does not point towards the door

hinges, remove it from the handle plate and

exchange with the other handle.

'D' pin

While holding the snib lever vertical,

place the lever assembly against the door.

hollow snib, to u

with caretaker

PLEASE TURN PAGE FOR INSTALLATION STEPS 8, 9 & 10

lockbody

sticker

rear slide

Cylinder installation

cylinder

cylinder cam

cam operation

'Caretaker' feature

cover plate

caretaker

spindle

Fit the correct Snib Lever

t o w

a r d s

h i n g

snib lever

snib with spindle, to use

without caretaker

Preparation

auxillary bolt

main bolt

cylinder

screw

caretaker

spindle fitted

interior handle

assembly

d o o

e s

(PK0234) ELEGANCE instructions (Trade A4) R5.cdr