Brenell Mark 610M Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для ВИДЕОМАГНИТОФОН Brenell Mark 610M. Brenell Mark 610M 10 страниц.

Печатать страницу

Switch Deck to Replay.

Adjust Vol.ume, Treble and Bass controls as required.

Remember that the A/8 Balance Control wi II

alter

the

replay level

adjust as necessary.

WARNING: DO NOT SWITCH DECK TO RECORD OR ERASURE

WILL OCCUR.

GENERAL INFORMATION

Fuses

The recorder may be operated in the horizontal or vertical position.

Should tape break or run out during recording or replaying the Take-up

motor (right hand) wi II automatically be switched off. The recorder

itself, however, will NOT be switched off; therefore, make a point

of ensuring that the deck's record/replay switch is turned to the "OFF"

position when the recorder is not in use.

leavin·

g the record/replay

switch in the "ON" position

mains switched off could cause flats

to develop on the rubber tyred pinch and idler wheels.

The back tension on the feed motor (left

ha~d)

may be adjusted by

turning the small recessed screw situated between this motor and the

speed change switch • Turning the screw in a

clockwise direction wi II

INCREASE the back tension. A change of tension is normally only

required when small reels or reels with very small diameter hubs are used,·

such reels .will require a REDUCTION of tension i.e.- turn screw

ANTICLOCKWISE. The normal setting for the screw is: "with a full 7"

reel of tape on the l.h. spoolholder the back tension should be just

sufficient to prevent the tape unreeling jerkily whel'l passing the heads at

a selected tape speed." The effect of excessive pressure will be to cause

"WOW" towards the end of the reel.

Clean the tape oxide ,from the heads at frequent intervals. A strip of

·cloth damp"fmed w:th water, or one of the many cleansing

fluid~

available

for cleaning tape heads, should be gently drawn to and fro across the

faces of the heads - each head being treated separately unti I all trace

of oxide is removed. The pinch wheel which presses the tape against the

capstan sleeve and the tape guides should be regularly cleaned with

dampened cloth (avoid using the cloth which will leave a deposit of fluff).

The meters wi II not oper~te unless the deck ~s switched to the record mode.

The tape movement may be immediately arrested if the pause control is

moved to the full extent of its movement.

If good quality

r~cordirigs

are to be made, it is essential that the tape be

fully and correctly, modulated as indicated by the meter readings rising to

OdB points on peak levels.

Two fuses are incorporated in this machine.

Mains Fuse

A 2 amp cartridge fuse which is mounted within the mains adjustment

plug

•.

For access remOve this plug (situated within the circular recess

at the rear of the cabinet) and carefully prise off the plastic co.ver from

the plug.

D.C. Fuse

A 1 .5 amp cartridge fuse (plus 1 spore) is mounted i'nternally. For access

.remove the ·two domed screws from the sides of the cabinet (FRONT ONLY) so

that the unit

may·

rais~

on its rear hinges.

1~-7

The 1 .5 amp fuses are mounted within the power unit in the rear

.h. corner

of the cabinet.

Brenell Engineering Co. ltd.

231-2~5

Liverpool Rood, London Nl1LY.

Telephone: 01-

607

8271'.