Bendcart BC-100 Инструкции по сборке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по сборке для Открытая тележка Bendcart BC-100. Bendcart BC-100 5 страниц.

The Bendcart is designed for use with the Greenlee #885T Hydraulic 2-1/2" to 4"

EMT benders and the #881 and 881CT 2-1/2" to 4" EMT and GRC bender.

SAFETY

Safety is an important part of the workplace. In addition to the normal workplace safety

measures there are specific precautions that should be taken when using the Bendcart:

-Be sure all pins are installed in the proper locations

-Visually inspect the bender to see that it is properly mounted and that there are no

parts missing or binding.

-Use proper lifting techniques when loading bender and changing parts

-Use only on a level surface

-The Bendcart is heavy, especially with extra shoes. Be very careful if moving over

uneven or sloping ground.

-The brakes are designed only to prevent the bender from moving when loading

conduit. They should not be relied upon when transferring or storing this unit.

LUBRICATION

The swivel wheels have grease fittings and should be greased every 6-12 months.

A light lubrication oil should be sprayed on the follow bar adjustment screw every

month.

MOUNTING THE BENDER (If you are mounting an 881 bender using the 881A

adapter consult the mounting instructions included with that piece of equipment.)

-Slide one of the bender side bars onto the bender support pins (see page 3)

-Slide the hydraulic cylinder onto the bender support pins

-Slide the second side bar onto the bender support pins

-Install the 2 hairpins into the proper holes to secure the bender to the Bendcart.

(NOTE: the 881 bender uses the outer holes, the 885T uses the inner set of holes)

-Install the follow bar roller

-Turn the follow bar adjustment handle to raise or lower the follow bar support

until it is approximately level with the top of the follow bar roller

-Lay the follow bar support strip across the follow bar support and the follow bar

roller with the warning labels up.

CAUTION: The support strip is not necessary for the proper operation of the

bender. It should not be used if it does not fit loosely between the steel rails of the

follow bar since it could cause damage to the follow bar and/or the support strip.

We are now using the adjustable follow bar support pegs (Part # BC100-0900)

in lieu of the follow bar support strip.

Bendcart

model

# BC 100

Instruction manual and parts identification

pg. 1