Bendcart BC-100 Инструкции по сборке

Просмотреть онлайн или скачать pdf Инструкции по сборке для Строительное оборудование Bendcart BC-100. Bendcart BC-100 5 страниц.

Remove all Cardboard

Review drawing on page 3 and 4 of instruction pack.

Pump Tray

Mount the pump tray by lowering the long bar down into the pump tray support tube on

the back of the Bendcart

Mount Bender Supports (2)

-remove the 3/8" bolts and spacers

-slide the bender supports over the frame top and cross member with the

support pins pointing away from the saddle and shoe storage posts

-reinstall spacers and bolts

-tighten bolts

Install conduit holddown roller

-remove the snap ring from the roller pin

-slide pin into one of the tubes on the back of the conduit leveler assembly (pg 4)

-the roller is built slightly off center. The center needs to be closer to the frame for

the 885 bender and further from the frame for the 881 bender.

--use lower tube when bending smaller size conduits

--use upper tube when bending larger conduits

-reinstall snap ring

Mount Adjustable follow bar supports (2)

- clip the support over the edge of the follow bar storage pan, one in front of the

bender and one behind.

-screw the 3/4" x 10" bolt into one of the tapped holes that is slightly below the

level of the bender roller. The purpose of these supports is to keep the follow

bar from sagging to the floor when pressure is released upon completion of the

bend.

Bendcart BC-100 assembly instructions