Bresser F004519 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары Bresser F004519. Bresser F004519 13 страниц. Electric background system

ENGINE CONTROL

PER CONTROL BOX

1. Press the [M] button (7) to set the desired motor (M1-M6). The

display (6) shows the number of the selected motor (1-6).

2. Press the s(8) or t(9) button to wind or unwind the background

roll attached to the selected motor.

BY REMOTE CONTROL

SET UP REMOTE CONTROL

IMPORTANT: Before using the remote control for the first time, it must

be set up. Proceed as follows:

1. Establish the power supply for the remote control and the motor

panel with the motors connected.

2. Press and hold the [M] button on the remote control for 3-5

seconds until a red dot flashes on the display (6) of the control box.

3. Press and hold the [M] button again for 3-5 seconds until the green

function light (10) on the remote control flashes. The setup is

complete.

USE REMOTE CONTROL

Once set up is finished, the remote control can be used as follows:

1. Press the [M] button (11) to set the desired motor (M1-M6). The

display (6) of the control box shows the number of the selected

motor (1-6).

2. Press the t(12) or s(13) button to wind or unwind the background

roll attached to the selected motor.

depending on model with 2, 3, 4 or 6 hooks /

depending on model 2, 3, 4 or 6 pieces included /

MOTOR PANEL/CONTROL BOX

Number of connectable motors: up to 6 motors

Voltage input: AC110-240V, 50~60Hz

Voltage output: DC24V/2.7A

Controller: Manually via control box or via remote control

Power: 50W per motor

Load capacity per level: maximum 20 kg

REMOTE CONTROL

Number of controllable motors: up to 6 motors

Power supply: 2 pcs. of 1.5V batteries, type AAA/LR03

Transmission frequency 2.4GHz ISM band

www.bresser.de/warranty_terms

not included /

available in hardware stores; use recommended for safety reasons