BENDIX SR-7 SPRING BRK MODULATING VALVE Приложения - Страница 7
Просмотреть онлайн или скачать pdf Приложения для Блок управления BENDIX SR-7 SPRING BRK MODULATING VALVE. BENDIX SR-7 SPRING BRK MODULATING VALVE 9 страниц. Spring brake modulating valve
Печатать страницу
NO CONTROL LINE
PRESSURE
SECONDARY RESERVOIR
CONSTANT PRESSURE
INLET / EXHAUST VALVE OPEN
FIGURE 11 - ANTI-COMPOUNDING
ANTI COMPOUNDING (FIGURE 11)
The SR-7
™
valve provides anti-compounding of the service and
spring brake forces. When the park brakes are actuated
(by pulling the dash valve button out), a service brake
application will cause the SR-7
to the spring brake chambers. Thus the vehicle is held
stationary using a service brake application. When the
service brake application is released, the delivery pressure
is exhausted from the spring brake chambers and the vehicle
remains parked using the spring brake actuators.
PREVENTIVE MAINTENANCE
Important: Review the Bendix Warranty Policy before
performing any intrusive maintenance procedures. A warranty
may be voided if intrusive maintenance is performed during
the warranty period.
No two vehicles operate under identical conditions; as a
result, maintenance intervals may vary. Experience is a
valuable guide in determining the best maintenance interval
for air brake system components. At a minimum, the SR-7
valve should be inspected every 6 months or 1500 operating
hours, whichever comes first, for proper operation. Should
the SR-7
™
valve not meet the elements of the operational
tests noted in this document, further investigation and service
of the valve may be required.
à
à
à
™
valve to deliver air pressure
à
à
à
à
OPERATING TEST
Block vehicle and hold by means other than vehicle brakes.
Charge air brake system to governor cut-out pressure.
1. Place parking control valve in "park" position. Observe
that spring brake actuators apply promptly. Remove
one line from delivery port of the SR-7
test gauge known to be accurate. Place parking control
valve in "release" position. Observe that spring brake
actuators release fully.
2. With parking control valve in "release" position, note
gauge pressure reading. (Correct spring brake actuator
hold-off pressure is 107 psi nominally.)
3. Place parking control valve in "park" position - gauge
reading should drop to zero promptly. A lag (more than
3 seconds) in drop of pressure would indicate faulty
operation.
4. With the parking control valve in the "park" position,
gradually apply foot brake valve and note a pressure
reading increase on the gauge installed in the SR-7
valve delivery port.
™
5. Place parking control valve in "release" position.
6. Drain the reservoir, which supplies the rear service brake
circuit, apply the foot brake valve several times and note
that pressure reading on gauge decreases each time
foot brake valve is applied (spring brake modulation).
After the foot brake valve has been applied several times,
pressure on gauge will drop to the point where release
of the spring brake actuators will no longer occur.
BALANCE PORT -
PRIMARY CIRCUIT PRESSURE
CONTROL PORT -
SECONDARY CIRCUIT PRESSURE
DELIVERY TO SPRING BRAKES
™
valve and install
™
7