BENDIX ET-S Руководство - Страница 3
Просмотреть онлайн или скачать pdf Руководство для Автомобильные запчасти BENDIX ET-S. BENDIX ET-S 8 страниц. Suspended electronic treadle
Печатать страницу
ACTUATOR
BASE
MOUNTING
PLATE
ACTUATOR
BODY
TREADLE
ARM
™
ET-S
TREADLE
FIGURE 5 - ET-S
™
AND ET-S2
All other repairs require replacement of the ET-S
™
ET-S2
treadle.
Refer to Figure 5 throughout the procedures.
Treadle Removal:
™
ET-S
Treadle
Position the treadle on its side with the potentiometer fac-
ing up. Remove the small retaining ring (3) and small nylon
washer (4) that hold the treadle on to the treadle arm and
set aside for the assembly process. After the washer is
removed, pull the treadle off, carefully releasing the pres-
sure from the treadle spring (7). Set the spring (7), nyliner
bearing (6) and the treadle aside for the reassembly pro-
cess. Inspect rubber treadle cover - replace if necessary.
™
ET-S2
Treadle
Position the treadle assembly on its side with the poten-
tiometer facing down. Remove the small retaining ring (3)
and the nylon washer (4) from the treadle pivot pin.
1
POTENTIOMETER
#10 SCREWS
7
SPRING
PIVOT PIN
™
TREADLE EXPLODED LINE DRAWING
2
3
RETAINING
RING
4
NYLON
WASHER
TREADLE
5
REPLACEABLE
RUBBER
COVER
™
(ET-S
TREADLE
ONLY)
6
NYLINER
BEARING
6
PIVOT PIN
NYLINER
BEARING
TREADLE
ARM
™
or
Remove the pivot pin from the treadle assembly. Gently
release the tension on the treadle spring (7) while removing
the treadle from the treadle arm. Remove the nyliner bear-
ing (6) from the treadle arm.
Potentiometer Removal:
Secure the mounting plate. Important: Do not clamp the
assembly by the treadle actuator body or base since
overclamping may cause the casting to be distorted.
Remove the two screws (2) that secure the potentiometer
(1) to the actuator base. The potentiometer (1) can then be
lifted away from the drive shaft.
CLEANING AND INSPECTION
1. Use suitable solvent to clean all metal parts (note that
mineral spirits may damage the paint finish).
2. Inspect the treadle and mounting plate for severe
corrosion, pitting, or cracks. Replace as necessary.
Superficial corrosion and/or pitting is acceptable.
NYLON
WASHER
RETAINING
RING
™
7
ET-S2
SPRING
TREADLE
TREADLE
4
3
3