BENDIX AUTOVUE FLC-20 Служебные данные - Страница 12
Просмотреть онлайн или скачать pdf Служебные данные для Автомобильные аксессуары BENDIX AUTOVUE FLC-20. BENDIX AUTOVUE FLC-20 16 страниц.
PRESSURE SENSOR, COVER,
AND GASKET REPLACEMENT
If a pressure sensor has been identified as faulty or
damaged, it must be replaced. (A service kit is available
from R.H. Sheppard.) Once the faulty or damaged
pressure sensor is removed, follow the steps below for the
installation of the new sensor.
1. Align the gasket and pressure sensor with the half circle
cut-out in each part. See Figure 10.
2. Align the pressure sensor and gasket on the bearing
cap. See Figure 10.
3. Hand start and torque the front right, and back left
pressure sensor bolts to 13-16 ft-lb (17.6-21.7 Nm) with
the 5 mm hex (Allen
Pressure
Sensor
Gasket
Figure 10 – Pressure Sensor and Gasket
12
) bit. See Figure 10.
®
Pressure
Sensor Bolts
Cut-Out
Magnetic Torque
Overlay Steering
Gear
4. Remove the alignment fixture (if used) and install the
pressure sensor cover by aligning the bottom tabs with
the open bolt holes. See Figure 11.
5. Hand start and torque the front left and back right bolts
to 13-16 ft-lb (17.6-21.7 Nm) through the tabs of the
pressure sensor cover with the 5 mm hex (Allen) bit.
See Figure 11.
MAGNETIC TORQUE OVERLAY
STEERING GEAR AND ECU
REPLACEMENT
To replace the steering gear or the ECU, please contact
the Bendix
Tech Team or Sheppard
®
See page 13.
Figure 11 – Bolt Installation
Technical Support.
®
Pressure
Sensor Bolts