BENDIX BDW46 Книга инструкций - Страница 18

Просмотреть онлайн или скачать pdf Книга инструкций для Посудомоечная машина BENDIX BDW46. BENDIX BDW46 20 страниц.

Печатать страницу

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot, securing it to the underside of the

work surface. This will prevent waste water from the sink

running into the machine.

2. Hooked over the edge of the sink using the special curved

plastic guide (if provided with the machine).

3. To a stand pipe provided with vent-hole, minimum internal

diameter 4 cm.

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could prevent

or slow down the discharge of water.

The sink plug must not be in place when the machine is

draining as this could cause the water to syphon back into the

machine.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

Attention!

Our appliances are supplied with a security device to protect

against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated

this can prevent the correct draining of your dishwasher.

We advise you therefore to remove it.

Electrical connection

This appliance must be earthed.

The manufacturer declines any responsibility should this

safety measure not be observed.

If the plug that is fitted to your appliance is not suitable for the

socket, it must be cut off and the appropriate plug fitted.

Important

The wires on the mains lead are coloured in accordance with

the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

If you fit your own plug, the colours of the wires in the mains

lead of your appliance may not correspond with the markings

identifying the terminals in your plug.

Proceed as follows:

1. Connect the Green and Yellow (earth) wire to the terminal

in the plug which is marked with the letter "E" or the earth

symbol

or coloured green and yellow.

2. Connect the Blue (neutral) wire to the terminal in the plug

which is marked with the letter "N" or coloured black.

3. Connect the Brown (live) wire to the terminal in the plug

which is marked with the letter "L" or coloured red.

CE04

The plug moulded onto the lead incorporates a 13amp BSI362

fuse. Only ASTA or BSI fuses should be used.

The plug must not be used if the fuse cover/carrier is lost. The

cover/carrier is indicated by the coloured insert at the base of

the plug.

A replacement cover/carrier must be obtained from your local

Service Force Centre.

To isolate the dishwasher from mains, remove the mains plug.

Important!

The plug must still be accessible after the appliance

has been installed.

The appliance should not be connected to the

electrical supply by means of an extension cable.

In case that the electrical cable has to be replaced,

please contact your local Service Force Centre.

Warning!

A cut off plug inserted into a 13 amp socket is a

serious safety (shock) hazard. Ensure that it is

disposed of safely.