dymax T17240 Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Промышленное оборудование dymax T17240. dymax T17240 20 страниц. Digital syringe dispenser

Печатать страницу

To use timer mode, you can either press the SHOT button on the front panel of the

SD-100 unit or press down on the foot pedal.

Cycle Mode

Cycle mode allows the user to create a repeating cycle of dispensing. This is programed

by setting a wait time between dispensing. This mode is reliant on the previous setting

that was made in timer mode to determine the length of dispensing during the cycle.

For example: If you would like to dispense for 1 second, then wait for 5 seconds, and

cycle these times over again, you would need to have already set your timer mode for

1 second (see previous page for these instructions). To set the 5 second wait time in

your cycle, follow the directions below.

Press the MODE button until the cycle mode is selected.

Press the SET button. The first digit on the right side of the digital display will start

blinking.

Press the ◄ button two times. The third digit from the right should be blinking.

Press the ▲ button five times. The display should now show a 5 second wait time.

(To adjust the decimal refer to page 15)

Press Exit/Mode to save as current setting.

To use the cycle mode, press the SHOT button on the SD-100 to activate the cycle. To

deactivate the cycle, press the EXIT button.

Saving Dispense to Memory

The SD-100 has the storage capacity for up to 9 programs that can be saved to its

memory for future recall. The memory will always save your current settings for the

particular mode you are in.

For example: If you want to save your current timer mode setting to Program 9, you will

first need to select timer mode then proceed with saving. You can also save your cycle

mode settings to Program 9 by following the same procedure.

To save your current settings to memory address 9, follow the instructions below.

While in timer or cycle mode, change to the mode you would like to save then

press and hold the MEM (Memory) key for 2 seconds until the unit beeps.

SD-100 Digital Syringe Dispenser User Guide