dymax 39560 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Измерительные приборы dymax 39560. dymax 39560 14 страниц.
Печатать страницу8
Dymax ACCU-CAL™ 50 Radiometer User Guide
Figure 5. Adapter Installation
4. Attach the Lightguide Adapter to the Spot Lamp Lightguide by inserting the Lightguide into the
Lightguide Adapter until it bottoms out. Tighten the set screw when the Lightguide is installed.
5. Press and release the On/Off Key on the Face Plate to turn the Radiometer on and off.
Figure 6. Attach Lightguide Adapter to Lightguide (Step 4)
6. Press and release the Light Source Key to select the light source being measured. The different light
source options are:
Flood Lamp - For use when measuring UV intensity of a flood-lamp light source.
3-mm Lightguide - For use when measuring UV intensity at the end of a 3-mm lightguide.
5-mm Lightguide - For use when measuring UV intensity at the end of a 5-mm lightguide.
8-mm Lightguide - For use when measuring UV intensity at the end of a 8-mm lightguide.
7. Press and release the Mode Key to select an operating mode. The different operating modes are:
Peak Intensity - Shows the highest UV intensity in mW/cm
measurement.
Intensity - Shows the UV intensity in mW/cm
Dose - Shows the total UV dose in mJ/cm
2
seen by the detector during the
2
at the detector during the measurement.
2
at the detector during the measurement.
Figure 7. Face Plate