Gacell SLC 93C Руководство пользователя - Страница 2
Просмотреть онлайн или скачать pdf Руководство пользователя для Зарядное устройство Gacell SLC 93C. Gacell SLC 93C 12 страниц.
Печатать страницуUSER MANUAL
ENGLISH
Before connecting charger to mains and battery READ THE INSTRUCTIONS
CAREFULLY
INSTALLATION
Connection to mains
It is essential to connect the charger to a mains supply corresponding to the power of the battery charger
installed and equipped with protection fuses (see kW value on rating plate).
Make sure to earth the charger properly.
Connection to battery
We advise the use of bipolar standard connectors which do not allow reverse polarity on battery.
Check cable connection in the connector contacts. In case of connection to a power supply protected by
Automatic Circuit Breaker, use only SWITCHES with D or K curve. Check mains voltage and adjust it, if
required, by means of the adjusting terminal board on the transformer.
The above check has to be performed by skilled personnel only.
OPERATION
• Once mains and battery connections have been performed, the card performs a lighting test of all LED's.
Then the green "BATTERY CONNECTED" LED remains lit (constant).
• In the standard configuration the "AUTOSTART" function is enabled (as default setting): the charger begins
automatically charging 5 seconds after connection to battery. The Autostart stage is indicated by the blinking
of the green "END OF CHARGING" LED, red "SAFETY TIMER" LED, and yellow "EQUALIZING CHARGE"
LED.
• If the Autostart function is disabled, press the GREEN button to start the charging process. The green LED
("CHARGING") begins blinking, and it will blink for the whole charging process. To stop charging, press the
GREEN button again.
• After the initial charge stage the yellow "FINAL CHARGE" LED will light up. Then an electronic timer starts
counting down the last three hours of final charge.
• When the final charge time has elapsed, the charger stops automatically and the green "END OF
CHARGING" LED lights up.
• One hour later an Equalizing charge will be performed (green LED blinking).
• A red LED indicates a FAULT. Should it light up, please contact service.
SAFETY INSTRUCTIONS
WARNING:
Skilled and authorised personnel only shall be allowed to open the
charger.
Before setting the charger at work, the insulation of power cord and
charging cable has to be checked.
WARNING:
Follow the manual of the charger and the battery closely.
WARNING:
The battery charger must be connected to supply mains by a qualified
personal in accordance with applicable local and national codes.
WARNING:
Check battery type and ratings before charging.
WARNING:
Charge only lead-acid type batteries in a well ventilated area. Other
types of batteries may burst causing personal injury and damage.
Batteries produce explosive gases while being charged, therefore there
must be neither flames nor sparks near the charger while it is in
eration.
The standard charger (IP 20) is to be used in closed and ventilated
environments only and not exposed to rain nor splashed with water.
WARNING:
To reduce the risk of fire, install battery charger on a floor of non-
combustible material, such as stone, brick, concrete or metal.
WARNING:
For continued protection against risk of fire, or electric
shock replace only with same type and rating of fuse.
WARNING:
The unit must not be used by unskilled or unqualified personnel,
children or people with reduced physical and mental abilities.
pag. 2
Revisione n° 0 del 17/11/2020