Adel CBI2410A Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Зарядное устройство Adel CBI2410A. Adel CBI2410A 4 страницы. Intelligent battery charger
Печатать страницу__________________________________________________Battery Charger
Battery Type Configurations
Position jumper Setting:
•
Open Lead (Charge): Trickle =2.23 Fast=2.40/cell
•
Sealed Lead (Charge): Trickle =2.25 Fast=2.40/cell
•
Sealed Lead (Charge): Trickle =2.27 Fast=2.40/cell
•
Gel Battery (Charge): Trickle =2.30 Fast=2.40/cell
•
Life Test Battery
•
No jumper no Fast Charge (pos. 5)
Compensation Recharges in temperature (Only version XXX/ARJ)
Connecting to RJ45 (AUXILIARY OUTPUT) cable RJTEMP (supplied separately), the CBI is will vary the tension of battery charging in
function of the temperature:
•
Fast Charge:
•
Trickle Charge:
If the sensor is not connected or if the sensor is defective, the led Low Batt is on and the led Diagnosis continues to show the status of
the battery: trickle charge, fast charge or recovery charge.
N.B.: the sensor place on cable RJTEMP must be applied on the battery.
Protection
On the primary side: the device is equipped whit a internally fuse T 6 A/250Vac. If the internal fuse is activated, it is most probable
that there is a fault in the device. If happen, the device must be checked in the factory.
On the secondary side Battery and load: The device is electrically protected against short circuits and overload.
Inversion polarity: the module is protected against inversion of battery polarity.
Over current and output short circuit: the unit limits the output current at max. 12 A in normal rating.
Deep discharge : not possible. The unit disconnects the battery when a minimum voltage level is reached.
Battery Test: Automatic. Every 20 sec. check polarity and battery. Every 4 hours in trickle charge, make the test of the battery
efficiency. The fault is signalized with relay commutation and diagnosis led blinking.
Characteristic Curves
Short circuit and overload
The output of the device is electrically protected against overload and short circuit.
At nominal voltage the device can supply 1.1 the nominal Current without
switching off. In the case of higher overload, the operating point traces the curve
illustrated in figure. As the overload increases, the output voltage is reduced until
zero.
Thermal behavior
The device supplies the nominal output current at ambient temperature of up 50°C.
For ambient temperature of over 50°C, the output current must be reduced by 1%
per °C increase in temperature. Max 70°C.
Standards and Certification
Electrical safety
The device must be installed in according with EN60950. The device must have a suitable isolating facility outside the power supply
unit, via which can be switched to idle.
General Standard
Immunity in according with EN50082-2, level 4, class B
Radio interference suppression in according with EN 55011 class A (industrial areas)
INSTRUCTION MANUAL
Caution:
Only jumper in position 5 Refresh ON/OFF state whit Power.
Notice: in the model CBIxxxA/S, without mains voltage,
closing the contact pos. 5 for 1 second and will start-up the
-5 mV/°C
-3 mV/°C
All specification are subject to change without notice
Switch off the system before Setting the jumper.
3
CBI2410A_R8 Eng.doc