HHC CH18HHC003 Инструкции - Страница 3

Просмотреть онлайн или скачать pdf Инструкции для Блок управления HHC CH18HHC003. HHC CH18HHC003 4 страницы. Hand control

Press this button to reduce the intensity of the back

massage.

Press this button to stop the back massage.

Press this button to increase the intensity of the foot massage.

Press this button to reduce the intensity of the foot

massage.

Press this button to stop the foot massage.

4.5.Backlit illumination of remote control

To illuminate the buttons for better night view when press this button . The light

will turn off automatically after approximately 10 seconds.

Note: The light also turns on when pressing any of the other buttons.

5. Matters needing attention：

5.1 Do not mix old and new batteries or different types of batteries in remote.

5.2 When the battery power is weak, electrolyte leakage may occur, and will damage the

remote. Once the power is low, replace the battery as soon as possible.

5.3 If the remote will not be used for a long period of time, remove the batteries to avoid

electrolyte leakage.

5.4 The battery should not be exposed to direct sunlight, fire, or other excessive heat. To

protect the environment, used batteries should be recycled in a proper manner.

6. Additional attention for user：

6.1 This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/ TV technician for help.

6.2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two

3/4