GAF Green Machine Инструкция по применению

Просмотреть онлайн или скачать pdf Инструкция по применению для Вентилятор GAF Green Machine. GAF Green Machine 12 страниц. Ecosmart dual-powered roof vent

Печатать страницу

DUAL

POWERED

EcoSmart Roof Vent

Safety Considerations and Warnings

1. Use appropriate safety glasses, gloves, hard hats,

restraints, and other equipment to avoid injury.

2. Wear durable work gloves while handling the unit

during installation. This product has sharp edges that

can cause injury.

3. Observe all applicable building codes in your area.

4. Do not damage electrical wiring or other hidden utilities

when cutting or drilling.

5. Make sure the fan blade is on tight and ensure the set

screw is securely tightened.

6. Use this unit only in the manner intended by GAF.

If you have any questions, please contact Master Flow

Technical Services at 1-800-211-9612.

7. Ducted fans must always be vented to the outdoors.

8. WARNING... DUAL POWER SOURCE! TO REDUCE

THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

a) Installation work and electrical wiring should be

performed by qualified persons in accordance

with applicable building codes and standards,

including codes for fire ratings.

b) Before servicing or cleaning unit:

• Switch power off at the service panel and take

all steps necessary to prevent power from being

switched on accidentally. If the service panel

cannot be locked, securely fasten a prominent

warning device, such as a tag, to the service

panel.

• Disconnect power leads from solar panel to

prevent accidental operation.

9. This fan should be connected to a circuit with minimum

14-gauge wiring that has at least 3 amperes of available

capacity. If you cannot confirm that there is sufficient

electrical capacity on an existing circuit, install a separate

dedicated circuit. DO NOT use an extension cord to

operate. All electrical wiring should comply with National

Electrical Code and all other local codes. Contact a

qualified electrician if you are not comfortable or

familiar with electrical codes and/or installations.

™

APPLICATION INSTRUCTIONS

10. FOR HOMES WITH A GAS OR OIL FURNACE

LOCATED IN THE ATTIC: The ventilator MUST be

wired with a switch or other interlocking device to

prevent the furnace and ventilator from operating at the

same time during the heating cycle. The switch or other

interlocking device MUST disconnect the vent unit from

both the electrical circuit power and the solar panel. We

recommend that the switch (not provided) be installed

by a qualified person in accordance with all applicable

codes and standards.

CAUTION: FOR GENERAL VENTILATING USE ONLY.

THIS FAN HAS AN UNGUARDED IMPELLER.

DO NOT USE IN LOCATIONS READILY ACCESSIBLE

TO PEOPLE OR ANIMALS. DO NOT USE TO

EXHAUST HAZARDOUS OR EXPLOSIVE

MATERIALS OR VAPORS.

Important: Your solar panel configuration may differ from

the one shown in the illustrations. The performance of all

configurations is the same.

Tools Required

• Drill

• Extension cord

• 1/8" Drill bit

• 7/16" Socket or adjustable wrench

• Utility knife

• Power saber or jigsaw and handsaw

• Safety eyewear

• Hard hat and other safety equipment

• Fall restraint equipment

• Galvanized roofing nails

• Caulking gun

• ASTM D4586 Type 1 or 2 Asphalt roofing cement

or ASTM C920 urethane sealant

• Work gloves

• Ladder

• Claw hammer

• Flat blade screwdriver

• Phillips-Head screwdriver

• Pencil or marker

• Tape measure

• 1/2" trade-size cable clamp connector

• Type NM electrical cable

• Wire nuts

V971390