Dawes Cycles Bicycle Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Велосипед Dawes Cycles Bicycle. Dawes Cycles Bicycle 16 страниц.

Печатать страницу

Quick Release Rear Wheel

Removal and installation of rear wheel fitted with quick release mechanism. Use same procedure as for standard rear

wheel, with the exception of loosening axle nuts. Operate the quick release lever by pulling away from the wheel 180° to

release the wheel.

When installing the rear wheel, position the wheel centrally in the frame, folding back the lever, then, when in position fold

the lever into its closed position.

Check quick release lever is in the correct and fully locked position before each ride.

Reset rear brake quick release mechanism and check brake for proper operation.

RIM WEAR LINE LIMIT INDICATOR

If your bicycle is fitted with disc brakes to the front and rear the following explanation is not applicable and can be ignored.

There are two types of safety warning line on the wheel rims, please check which version is fitted to your bicycle and note

the relevant instructions which follow.

Concealed Safety Line

This type of safety line is not visible as it has been constructed within the aluminium braking surface. When the rim has

been subjected to extended braking and the rim surface is sufficiently worn to warrant replacement, the safety line will

appear in the rims braking surface. This can be recognised as a 1mm groove in the centre of the braking surface.

THE RIM MUST BE REPLACED BY A PROFESSIONAL CYCLE MECHANIC BEFORE THE BIKE IS RIDDEN.

Visible Safety Line

This type of safety line is already machined and is visible in the aluminium braking surface. When the rim has been

subjected to extended braking and the rim surface is sufficiently worn to warrant replacement, the safety line will

disappear and the rims braking surface will be one continuous smooth surface.

THE RIM MUST BE REPLACED BY A PROFESSIONAL CYCLE MECHANIC BEFORE THE BIKE IS RIDDEN.

WARNING! Do not attempt to ride the cycle until you are absolutely sure that all quick release levers are fully closed

and securely tightened.

FITMENT OF BELL

Remove screw from bell clamp.

Position in a convenient spot near the left hand or right hand handlebar grip.

Replace screw & tighten securely.

Rotate the "Ping Arm" to a comfortable position.

WARNING

Check for the letters "L" or "R" on the ends of the pedals to show which side the pedal needs to be fitted to.

TO FIT RIGHTHAND PEDAL

TO FIT LEFTHAND PEDAL

Tighten Clockwise

Tighten Anti-clockwise

Brake Lever/Shifter

Ping Arm

Position Bell on left hand or right

hand side of the handlebar as

required.

Fit to chainside of cycle.

The pedal tightens in a

clockwise direction,

towards the front of the

bicycle.

Locate thread by hand, fit

and tighten.

Use spanner to finish

tightening (be careful)

Fit to non chainside of cycle.

The pedal has a special

thread to tighten in an anti-