Gage Bilt GB2480 Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Инструменты Gage Bilt GB2480. Gage Bilt GB2480 10 страниц. Hydraulic installation tool

WARNING

Be sure powerunit is disconnected before cleaning, or when replacing worn or damaged components. Se-

vere personal injury may occur if power source is not disconnected.

TROUBLE SHOOTING

Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.

1. NO OPERATION WHEN ACTUATOR IS DEPRESSED

a.) Check powerunit power source.

b.) Control cord may be loose or damaged.

c.) Faulty actuator. Replace.

d.) Check hydraulic couplings; tighten, repair or replace.

2. SLOW OR PARTIAL OPERATION WHEN ACTUATOR IS DEPRESSED

a.) Low hydraulic pressure. Check powerunit, adjust.

b.) Cylinder Piston o'ring (2) could be worn or damaged. Replace.

c.) Solenoid pin in directional valve on powerunit worn or peened over. Replace.

d.) Excessive wear or scoring on moving parts. Check and replace faulty parts.

3.TOOL OPERATES IN REVERSE

a.) Tool stops in back position. Hydraulic hoses are reversed. Correct.

4. HYDRAULIC OIL OVERHEATS

a.) Powerunit motor rotation reversed. Electrical connections reversed. See powerunit instructional

manual.

b.) Restrictions in either hydraulic lines, hoses or couplings. Check and Tighten, clean or replace.

5. OIL LEAKAGE

a.) Hydraulic oil leaks from connections. Tighten threaded connections. Do not use Teflon® tape.

b.) Oil leaks from tool. Determine source of leak and replace worn or defective o'rings and back-up

rings.

6.PINTAIL GROOVES STRIPPED DURING PULL STROKE

a.) Nose Assembly must be pushed onto fastener fully.

b.) Chips may have collected in chuck jaws. Disassemble nose assembly, clean jaws in mineral

spirits using sharp pointed object and re-lube surfaces jaws ride on.

c.) Chuck jaws may be worn or damaged. Replace

d.) Pintail too short for jaws to properly grip. Select proper grip length fastener.

e.) Excessive gap between sheets. Reduce gap before attempting to install fastener.

7. NOSE ASSEMBLY WON'T ACCEPT FASTENER PINTAIL

a.) Spent fastener stem may be jammed in pulling head. Disassemble and check for worn or broken

parts in nose assembly. Replace defective parts, clean and re-lube before reassembling.

9/11 REV. 7/13