Gage Bilt GB722 Оригинальное руководство по эксплуатации - Страница 14

Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Электроинструмент Gage Bilt GB722. Gage Bilt GB722 20 страниц. Installation tool
Также для Gage Bilt GB722: Руководство по установке (13 страниц), Оригинальное руководство по эксплуатации (20 страниц)

WARNING:

Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if

power source is not disconnected.

CAUTION:

Actuator assembly-air (704130) can break if not careful.

CAUTION:

Do not over tighten actuator assembly-air (704130). Snug tighten only.

REMOVING ACTUATOR ASSEMBLY-AIR (704130)

Remove actuator lever assembly (704343) including pin-slotted (400608) from handle assembly (722132).

Insert a 5/8" open end wrench / adjustable wrench around actuator assembly-air (704130).

Loosen the actuator assembly-air (704130).

Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from the handle

assembly (722132).

INSTALLING ACTUATOR ASSEMBLY-AIR (704130)

Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.

Thread the actuator assembly-air (704130) all the way into handle assembly (722132) with fingers.

Insert and turn 5/8" open end wrench / adjustable wrench and snug tight approximately 1/4-1/2 turn.

Reinstall actuator lever assembly (704343) with pin-slotted (400608) to handle assembly (722132).

GB722 S/N: 1753 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

OVERHAUL

ACTUATOR ASSEMBLY-AIR

REV. 5/22