Gage Bilt GB745SHAVT Оригинальное руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Заклепочные инструменты Gage Bilt GB745SHAVT. Gage Bilt GB745SHAVT 20 страниц. Installation tool

Печатать страницу
WARNING:
Only qualified and trained operators shall install, adjust or use the assembly power tool for non-threaded
mechanical fasteners.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing protection and safety boots be worn at all times while handling this equipment.
WARNING:
The users or the user's employer must assess specific risks that could be present as a result after each use based on their
application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of
any moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
● Verify that hydraulic hose fittings and couplings, air and electrical connections are secure.
● Verify
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool
●
Do not use as a hammer to force fasteners into holes or otherwise abuse tool.
WARNING:
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start-up.
WARNING:
Do not operate this tool without deflector, pintail catcher bag or pintail collection bottle in place
CAUTION:
Do not use beyond the design intent.
Lockbolts
1. Insert fastener through the work piece.
2. Slide collar over fastener.
Note: Always hold tool so pulling head is perpendicular to surface
of material in which fastener is being installed. Exert firm pressure
against fastener during installation.
3. Insert fastener into nose assembly.
4. Press actuator to start cycle.
5. Release actuator as soon as fastener breaks.
6. Repeat steps 1-5.
GB745SHAVT INSTALLATION TOOL

HOW TO USE THE GB745SHAVT

MUST
read and understand all warnings and cautions.
the air lines and/or hydraulic hoses are not a trip hazard.
Images may not reflect actual tool or fastener
Blind Fasteners
1.
Insert fastener into workpiece.
2.
Insert fastener into nose assembly.
Note: Always hold tool so pulling head is perpendicular to surface
of material in which fastener is being installed. Exert firm pressure
against fastener during installation.
3.
Press actuator to start cycle.
4.
Release actuator as soon as fastener breaks.
5.
Repeat steps 1-4.
9
7/21 REV 5/22