Great American Recreation Power Hockey Overhead Инструкция по сборке Руководство - Страница 4
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Аркадные игровые автоматы Great American Recreation Power Hockey Overhead. Great American Recreation Power Hockey Overhead 13 страниц.
Печатать страницу1. Locate string taped to the side of the Power Hockey table.
2. Remove tape and pull out wire harnesses attached to the string.
3. Attach Light Bar with wire to the side on the table with exposed wire harnesses, using
(6) 1 1/2" x 1/4" #20 bolts and 6 locking washers.
4. Attach remaining Light Bar to the other side of the table in the same way.
5. Attach Light Fixture to the Light Bars using: (4) 1/4" x 1/4" #20 bolts, (8) 1/4" washers,
(4) 1/4" locking washers, and (4) 1/4" nuts. (See figure 2)
Score Panel
5/8" pan head screw
Light Bar
Light Fixture
6. Connect wires from Light Fixture (2 pin connector) to matching connector in Light Bar.
7. Attach 25 pin harness from light bar to the Score Panel at connector marked
"INTERFACE". NOTE: Make sure the notches on the harness face center of the
circuit board when you attach it to the board.
8. Screw score panel to the light assembly with (4) 5/8" #8 pan head screws.
9. Connect three wire harnesses to their mates at the base of the light bar.
10. Attach Large Light Bar Mount Cover at the base of the Light Bar with the wires using
(2) 5/8" #8 pan head screws.
11. Attach the Small Light Bar Mount Cover on the opposite side.
Light Bar Assembly
1/4" washer
1/2" x 1/4" #20 bolt
FIGURE 2
1"
1/4" nut
1/4" locking washer
1/4" washer