Frigidaire 79071190100 Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Диапазоны Frigidaire 79071190100. Frigidaire 79071190100 10 страниц. 30" gas range with electric ignition or standing pilot

Печатать страницу

7. Air adjustment

The air shutter(adjustment)for each ofthe fourtop burnersis

located at the open end of the venturitube and sets on the

hood of the valve,

Should the air shutter need adjusting, rotate the air shutterto

allow more or less air into the burner tubes as needed.

Adjustment

If the air is properly adjusted, the flame will be steady,

relatively quiet, and have approximately 1/2" sharp blue cone.

(Usually about the center of air shutter's ajustment.)

If the flameis yellow in color, increaseair shutter openingsize.

If the flame isa distinctblue, butliftingaway from the burner,

reduce the air shutter openingsize.

8. Adjust the "LOW"

Setting of Linear Flow

Surface Burner Valve :

Sun'ace

Burner

Operation of Oven Burners and

Oven Adjustments

9a, Electric

Ignition

Burners

Operation of electric ignitersshould be checked after range

and supply line connectors have been carefully checked for

leaks and range has been connected to electric power.

The oven burner is equipped with an electric control system

as well as an electric oven burner igniter. If your model is

equipped with a waist-high broil burner, it will also have an

electric burner igniter. These control systems require no

adjustment. When the oven is set to operate, current will flow

to the igniter. It will "glow" similar to a light bulb. When the

igniter has reached a temperature sufficient to ignite gas, the

electrically controlled oven valve will open and flame will

appear at the oven burner. There is a time lapse from 30 to 60

seconds after the thermostat is turned ON before the flame

appears at the oven burner. When the oven reaches the dial

setting, the glowing igniter will go off. The burner flame will go

"out" in 20 to 30 seconds after the igniter goes "OFF." To

maintain any given oven temperature, this cycle will continue

as long as the dial (or display) is set to operate.

After removing all packing materials and literature from the

oven:

a) Set oven to BAKE at 300-°F. See Owner's Guide for

operating instructions.

b) Within 60 seconds the oven burner should ignite. Check

for proper flame, and allow the burnerto cycle once. Reset

controls to off.

If your model is equipped with a waist-high broiler, set

oven to BROIL. See Owner's Guide for operating

instructions.

d) Within 60 seconds the broil burner should ignite. Check

for proper flame. Reset controls to off.

a) Turn control to LITE until burner ignites.

b) ._

turn knob to LOWEST POSITION.

If burner goes out, readjust valve as follows:

Reset control to OFF. Remove the surface burner control

knob, insert a thin-bladed screw driver into the hollow valve

stem and engage the slotted screw inside. Flame size can be

increased or decreased with the turn of the screw. Adjust

flame until you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the flame. Flame should be

as small as possible without going out.