Agrident AIR200 Руководство по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке для Rfid системы Agrident AIR200. Agrident AIR200 11 страниц.

AIR200

6. FCC digital device limitations

Radio and Television Interference

This equipment has been tested and found to comply with the limits for a digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference, in which case the user will be required to correct the interference

at his own expense.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

In order to maintain compliance with FCC regulations, shielded cables must be used with this

equipment. Operation with non-approved equipment or unshielded cables is likely to result in

interference to radio and television reception.

Caution! Changes or modifications not expressly approved by the manufacturer could void the

user's authority to operate this equipment.

7. CANADIAN RADIO EMISSIONS REQUIREMENTS

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites

applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le

brouillage radioelectrique edicte par le ministere des Communications du Canada.

Industry Canada:

Operation is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.

This device has been designed to operate with the antennas listed below, and having a

maximum gain of 1.8 dB. Antennas not included in this list or having a gain greater than 1.8 dB

are strictly prohibited for use with this device. The required antenna impedance is 2.8 ohms.

- Stick Antenna AEA080

- Stick Antenna AEA120

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted

for successful communication.

8. CE MARKING

Hereby, Agrident BV declares that this equipment, if used according to the instructions, is in

compliance with the essential requirements and other relevant provisions of the RTTE Directive

1999/5/EC. For use in all countries of the EU.

10.07.06

Installation

Page 10 of 11