6K Products 25G36 Руководство по эксплуатации и запчастям - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и запчастям для Промышленное оборудование 6K Products 25G36. 6K Products 25G36 17 страниц. Connect and cut hydraulic chain

Bar Oil Pump Adjustments
The DH0144 bar oil pump (Fig. 9) is a single acting pump that can pump up to 32 cc, or 1.08 oz., of bar oil per cycle,
enough for about 30 seconds of cutting. There is a hose connected to the feed and motor control valve manifold
(Fig. 8, item 6) that connects to the fitting (Fig. 9, hydraulic pressure in) on the bar oil pump. When a cut is started
flow and pressure from the manifold pushes on the pumping rod and piston to force a metered amount of oil to the
bar. Very little rotational adjustment is needed for the metering valve in Figure 9. Turning it clockwise reduces the
speed oil is pumped and turning it counterclockwise increases the speed the oil comes out. If you run the tank out of
oil you may need to prime the pump. To prime the pump remove the barrel nut and pull out the pumping chamber,
pumping piston, and pumping rod. Fill the barrel with bar oil up to the vent hole. Reinstall the pumping rod
assembly into the pumping chamber with care to not damage the rod seal. Reinstall the pumping chamber and
pumping rod assembly into the barrel, with care to not damage the piston or the O-ring, and retighten the barrel
nut. To reduce the chance of seal damage make sure the seals are oiled and wiggle in a circular motion as you push
the parts together.
Fig. 9
9