Hi-Force TLE5010 Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Джеки Hi-Force TLE5010. Hi-Force TLE5010 18 страниц.

5.4 Moving & Positioning the ToughLift

1. Adjust the handle into the most comfortable position by [1] pulling up on the handle release (6) and

[2] rotating the handle (7) to the desired position. [3] Let go of the handle release (6) and allow the

locating pins to engage the handle latch-pin holes (18) on the side of the ToughLift main housing

(See figure 5.1).

2. Use the handle (7) to tilt the jack right back onto its wheels, allowing it to be manoeuvred to its

required location (See figure 5.2).

3. Position the jack accurately under the lifting point by adjusting the handle to its lowest position and

tilting the jack back slightly onto its wheels (See figure 5.3).

This allows the jack to be moved while the 'V-Lift' system keeps the cylinder vertical.

4. Make sure the cylinder saddle (5) is central to the lifting point before the lift is started.

ALWAYS make sure the jack is positioned directly under the load and lifts vertically.

Figure 5.2: Moving the Unit

Make sure that when the base plate is lowered to the floor and the handle is

allowed to rise back up, your hands are clear of any pinch points above.

Figure 5.1: Handle Adjustment

Operating Instruction Manual:

OM-TLE50-01

Figure 5.3: Accurate Positioning of the Unit

From Serial Number:

All