Hi-Force TLE5014 Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Джеки Hi-Force TLE5014. Hi-Force TLE5014 18 страниц.

5.1 Before First Use / Preparation

1. Immediately after unpacking, examine the unit for signs of transit damage and if found contact the

shipping company.

2. Establish the oil level in the oil reservoir (15) using the oil level gauge (16). Depending on the

shipping method used, the reservoir may either be supplied full or empty. If the reservoir is empty,

it must be correctly filled before use (See section 5.2). If the reservoir was supplied full of oil, no

further action is required.

IMPORTANT:

Running the pump without oil will result in damage.

5.2 Filling the Reservoir with Oil

IMPORTANT:

The TLE50 Range uses ISO46 Grade Hydraulic Oil.

•

Stand the ToughLift on a firm, level surface.

•

Open the Top Cover (12), by removing the 6 Cap Screws (17) holding the cover in place. (See figure

4.3 Item 17 for screw locations)

•

Remove the filler cap (19) from the filler breather.

•

Fill the reservoir with clean, high-quality ISO46 hydraulic oil via the filler breather until the oil level

reaches the centre of the upper oil level gauge sight-glass (16).

•

Replace the filler cap (19) on the filler breather.

•

Replace the Top Cover (12) and 6 Cap Screws (17). DO NOT operate the ToughLift without the Top

Cover securely in place.

Ensure the oil level does not fall below the minimum level. Running the pump without oil

will result in damage.

IMPORTANT:

Only add oil to the reservoir when the lifting cylinder is fully retracted. Failure to do so will

result in the system containing more oil than the reservoir can hold.

5.3 Priming the Pump / Bleeding Trapped Air from the System

If the unit is delivered without oil or if air becomes trapped in the system, it will need to be primed/ bled.

To do this, fully advance and retract the cylinder (unloaded) several times until operation is smooth.

Operating Instruction Manual:

OM-TLE50-01

5.0 Installation/ Setup

From Serial Number:

All