6TL YAV90132 Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Блок управления 6TL YAV90132. 6TL YAV90132 13 страниц. 32 channel, 2a spdt relays
Печатать страницу
8.
LED BEHAVIOUR
LED Name
LED Behaviour
STATUS
Off
Solid green
Blinking green
LED behaviour
9.
SWITCH CONFIGURATION
Switch
Name
SW1
1 & 2
3 to 8
SW1 behaviour
Switch ID
Description
SW2
BOOT0
SW3
RESET
SW4
CAN-END
Switches description
Pag 8 | 13
www.6tlengineering.com
Board is not powered on or power supply is not reaching the
microcontroller.
Board is powered on, but firmware of microcontroller is not present or
is not running due an error.
Board is powered on and firmware is running properly.
Pin switch
Switches 1 and 2 set the CAN communication speed:
The logic address is composed by 2 elements: the module
identification and the hardware address. The module identification is
set on firmware and cannot be changed. The hardware address is
selected by switches 3 to 8, being 3 the least significant bit (LSB) and
8 the most significant bit (MSB):
Factory use. Must be OPEN on operation.
Must be OPEN on operation. A temporary bridge causes a reset of the board.
Placing jumper adds a 120 Ohm resistor between the CAN-High and CAN-Low
signals of CAN-Bus.
18/06/2022 YAV90132 / YAV90133
Definition of Behaviour
Definition of Behaviour
00 = 50 kbps
10 = 100 kbps
01 = 125 kbps
11 = 250 kbps
ON
ON=1
OFF=0
1 2 3 4 5 6 7 8
LSB
MSB
Board Address
Definition of Behaviour