Gaggenau AI 201 Руководство по эксплуатации и сборке - Страница 16

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и сборке для Вентиляционная вытяжка Gaggenau AI 201. Gaggenau AI 201 19 страниц.
Также для Gaggenau AI 201: Руководство по эксплуатации и сборке (20 страниц)

Печатать страницу

200

Fig. 19

Fig. 20

Circulating air mode only

Fig. 21

346

Note:

the extractor hood is to be installed to a kitchen

ceiling or suspended ceiling. Ensure that the

ceiling is capable of providing a firm hold for a

maximum weight of hood and accessories of 45 kg.

Before marking the securing holes, make sure that

no electricity wires or water pipes or other wires/

pipes are laid at the drilling points in the ceiling.

Before installation check the enclosed wall plugs

and screws are suitable for your ceiling. If

necessary use special wall plugs.

Installation of the extractor hood:

Using the drilling template mark the position of

the screws on the ceiling.

2. Drill 4 holes Ø 8 mm for the wall plugs. Push the

plugs flush with the ceiling (Fig. 19).

Turn two screws to a 10 mm gap. Both screws

are placed in a position, in which at a later stage

of the installation the key-holes of the supporting

frame are found (namely back left and front

right from the control panel of the hood).

4. Adjust the support frame to the desired height

and secure with 8 screws (12 screws for the

longer ventilation ducts). The length of the

support frame can be adjusted in steps of

20 mm (Fig. 20).

Note:

ensure that the minimum distance between the

hob and the extractor hood is maintained -

600 mm for an electric hob and 650 mm for a

gas hob.

Circulating air mode

brackets, which fix the circulating air switch module

to the top of the support frame. These should be

bent outward in a 90° angle (Fig. 21).

only:

there are four