2gig Technologies Vario Руководство по быстрой установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Система безопасности 2gig Technologies Vario. 2gig Technologies Vario 18 страниц. Voice module
Также для 2gig Technologies Vario: Руководство по установке (6 страниц), Краткое руководство пользователя (10 страниц)

2gig Technologies Vario Руководство по быстрой установке
7. Set the Main Unit DIP Switches
DIP Switch 1
1: Bell
2: Default
3: Extern—Back Tamper
Bypass
4: Intern—Front Tamper
Bypass

Connecting BUS Detectors

Up to 23 addressable BUS detectors can be assigned to the 2GIG Vario system. BUS detectors can be wired to the main BUS or to a BUS zone expander.
For full installation instructions, refer to the instructions supplied with each BUS detector.
Connecting BUS Detectors to the Main 2GIIG Vario System BUS
1. Set the BUS detector ID number (1–32) using the detector's DIP switches.
NOTE:
For WatchOUT, LuNAR, WatchIN, BWare, and Seismic, set the switch that defines the detector operation mode to BUS mode.
2. Wire the BUS terminal's AUX (RED), COM (BLK), BUS (YEL, and BUS (GRN) to the 2GIG Vario system BUS.
NOTE:
For maximum operation stability, it is best NOT to exceed a total of 300 meters (1000 feet) of wiring from the BUS detector to the
2GIG Vario system panel.
Connecting BUS Detectors Using a BUS Zone Expander
1. Set the BUS zone expander ID number (1–3) using the DIP switches SW1 1–3.
2. Set the BUS zone expander SW2–3 to ON.
3. Wire the BUS zone expander terminals labeled TO PANEL to the 2GIG Vario system BUS.
8
ON: For bell or electronic siren with a built-in siren driver.
OFF: (Default) Fr loudspeaker without a built-in sound driver.
ON: Resets installer, sub-installer, and grand master codes to their default factory values
and bypasses main unit front tamper alarm.
OFF: (Default) Preserves the set values for the codes.
ON: Back tamper bypass is in effect. Use this setting during programming and if no back
tamper has been connected to PLUG 2.
OFF: (Default) No tamper bypass is in effect.
ON: Front tamper bypass is in effect. Use this setting when the 2GIG Vario system is
installed inside the metal enclosure.
OFF: (Default) No tampe bypass is in effect.
Status
Copyright © 2016 Nortek Security & Control LLC
2GIG Vario Quick Install Guide