Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Система безопасности Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System. Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System 13 страниц.

Печатать страницу
prevent any children from bumping onto it
 Fix the part of emitting onto the door frame, make sure to keep the part of magnet and part of emitting in parallel, the
space between the two parts shall be less than 10mm
 Upon the working light flashes frequently in red, please replace the batteries
How to program
Please refer to the descriptions of 【Set Smart Zone】.
Note:
You can only add 1 wireless door magnet each time, totally 4 available to be added.
Each serial number is available to study 1 wireless door magnet, the latter configured wireless door magnet will
be workable and the former one becomes not workable automatically.
Wireless Door Sensor (Sames as Wireless Intelligent Door Sensor)
How to program
Please refer to the descriptions of 【Program Sensor】or Table 6.

Wireless wide-angle PIR Sensor

Working Light
Lens
Features:
 Mainly monitor and control indoor space, generally set as Motion zone.
When human body enters into etecting area, the sensor will transmit alarm signals to the alarm host.
Specifications:
 Operating power: 9V alkaline battery
 Emitting distance: ≥100m (in open area)
 Service life: ≤1 year
 Detecting distance: 110° 10×10m
Installation and Usage
 Fix the bracket on suitable wall surface or in wall corner at a distance of 2~2.4m above the ground;
 Open the sensor shell to connect the batteries well and adjust jumper line (short circuit "5S": The sensor will detect
once every 5 seconds; short circuit "5MIN": The sensor will detect once every 5 minutes;
Suggestion: short circuit "5S" for testing and "5MIN" for normal use;
 Fix the sensor onto the bracket;
 Adjust the sensor to a proper angle and then slide the power switch on the side to "ON", and it will enter into the
normal working state after 30 seconds;
 Upon the working light flashes frequently in green, please replace the batteries.
How to program
Install the bracket
Wall
Wall
0 2 1
D0
D3
Low-Votage
Light
Fix the PIR by pushing
it downwards
Wall
Power Switch
Down/Off
Up/On
Learning Emitting Switch
Jump Line
Keep the switch "on"