GREAT PLAINS 605NT Руководство по техническому обслуживанию
Просмотреть онлайн или скачать pdf Руководство по техническому обслуживанию для Сельскохозяйственное оборудование GREAT PLAINS 605NT. GREAT PLAINS 605NT 7 страниц. Six foot no-till
Печатать страницу
SIX
FOOT
NO-
TILL
605NT / 606NT
3P605NT / 3P606NT
Proper servicing and adjustment is the key to the long life of any farm implement.
With careful and systematic inspection of your grain drill, you can avoid costly
downtime and repair.
1) After using your drill for several hours, check all bolts to be sure they are tight.
Refer to the torque value chart in your operator's manual.
2) A) Lubricate the seed cup drive sprocket shaft by coating with Never Seeze.
B) Lubricate all chains with chain lube.
C) Grease the clutch cam fittings. With the clutch jaws in the open position,
lubricate with slip plate or a chain lube between the jaws.
D) Grease the coulter arm pivots every 6 to 8 hours.
E) Grease the wheel arm pivot castings every 6 to 8 hours.
F) Grease coulter hub bearings and end wheel hub bearing before start of
each planting season.
3) Disk scrapers should be properly adjusted.
4) Check for the proper air pressure in the implement tires.
The 605NT 9.5L x 15"is 44 psi.
The 3P605NT 5.70 drive wheel tire is 50 psi.
5) Check all chain idlers for proper adjustment. To adjust the chain in the drive axle
tube, loosen jam nut on top of axle tube and screw adjusting stud in to tighten the chain
and retighten jam nut.
NOTE: DO NOT OVER TIGHTEN CHAINS.
01-12
DRILL MAINTENANCE
(1/4" deflection per foot between shaft centers vertical drive)
(1/2" deflection per foot between shaft centers horizontal drive)
(All drives with more than 3 feet between shaft centers should be
Adjusted to 1/4" deflection per foot between shaft centers
).