Active-semi HYDRA-X10 Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Материнская плата Active-semi HYDRA-X10. Active-semi HYDRA-X10 16 страниц. Power application controllers

Печатать страницу

SWD Debugging

The HYDRA-X10 module comes equipped with a fully operational and ready to be used CoLinkEx compatible

SWD debugger. User can utilize this link to download code to the PAC5210 device through the CooCox IDE

or CoFlash FLASH loader application. Both of these applications, along with the CoLinkEx USB driver, can be

downloaded from the

www.coocox.org

In the event the user desired to utilize a different debugger, connector J1 offers access to the PAC5210 SWD

lines. The CoLinkEx debugger must be separated. Separation can be obtained by flipping the S2 DIP

switches 3 and 4 to the OFF position.

The integrated SWD module is powered from the PAC5210's 3.3V regulator.

SWD Jumper/Shunt and Push Button

Jumper

Description

JP1

Used to program U3 microcontroller with CoLinkEx SWD firmware. In Factory use only.

SWD MCU Reset Push Button

The S1 push button resets the SWD MCU. In the event SWD communications are not operational while all

voltages are present, pushing the button may restore SWD functionality.

NOTE: It is highly recommended the JP1 to never be populated with a shunt. Doing so will configure the SWD

MCU to behave like an USB storage device. This mode is only meant to be employed when programming the

SWD MCU with the CoLinkEx firmware.

website.

Figure 4 S2 DIP Switch Debugger Selection

Rev 1.0 June 2014