7LS MD7-1000 Руководство по эксплуатации и гарантийные обязательства - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и гарантийные обязательства для Средства личной гигиены 7LS MD7-1000. 7LS MD7-1000 20 страниц. Microdermabrasion+ cooling surface

Печатать страницу

H O W T O U S E

B E F O R E T U R N I N G T H E U N I T O N

• Make sure the unit is fully charged

• Confirm the placement of the black wool filter

• Install the desired diamond tip on the hand unit

C H A R G I N G T H E B A T T E R Y

Before turning the unit on, connect the charging base to a household electrical outlet

using the USB charging cord and adapter. Place the handle in the charging base and

press down firmly. The LED lights will flash to indicate that charging is taking place.

When charging is complete, all the lights will remain on. It takes 4 hours for a full charge,

which will provide 90-120 minutes of use, dependent on power levels used. When the

level indicator LED flashes red, it indicates that the product needs charging.

B L A C K W O O L F I L T E R S

A new black wool filter must be installed prior to the first use and before each use of

the device. The filter collects dead skin cells and should be disposed of after use and

then replaced.

NOTE: Using the device without a filter will allow debris and dead skin cells to enter the

motor, shortening the life of the product.

W H A T T O E X P E C T

Regular microdermabrasion treatments can both restore and maintain a youthful

appearance to the skin. We advise starting slowly with just one or two treatments a

week, then building up to treatments every other day, if desired. During use, you should

feel a gentle suction effect as the tip moves across the skin. Some people may also

notice the slight coarseness of the diamond tip. Depending on your skin type, you may

experience some reddening or increased sensitivity after treatment. This is perfectly

normal and usually subsides within a few hours. You may wish to consider using the

cooling surface on treated areas and make your first treatment at the end of the day

rather than just before going out. Adverse reactions are rare, but if skin becomes unduly

inflamed or irritated, stop using the device immediately.

H O W T O U S E

AREA

CHEEKS

AROUND LIPS & CHIN

MAX LEVEL

(Level 3)

(Level 2)

ROUTINE

NOTE: Avoid the sensitive areas immediately above and below the eye.

F A C I A L T R E A T M E N T R O U T I N E

• Wash and dry your face.

• Remove the handle from the charging base and fit your choice of diamond tip with

a new black wool filter.

• Press and hold the power

button for 1 second to turn the unit on. Press the power

button again as required to increase the power level, as indicated by the LEDs. It

is recommended to start on level 1 for the first treatment and to progress to a higher

level if comfortable. See also max recommended levels in the above illustration.

• Place the diamond tip flat against the skin until you feel suction. Move it slowly across

the surface of the skin in a smooth motion, covering the same area no more than 2-3

times in one treatment. Do not press too firmly as this may cause irritation. In some

areas, it can help to hold the skin taught with the other hand (i.e., around the eyes).

• The illustration above will help you establish an effective facial routine.

• Press and hold the power

button for 1 second to turn the unit off.

A F T E R T R E A T M E N T C O O L I N G S U R F A C E

• Press and hold the cooling button for 1 second. A blue LED will glow indicating the

cooling surface is activated.

• Apply the cooling surface to the treated area to soothe the skin post-treatment.

AROUND EYES

FOREHEAD

NOSE

(Level 1)

(Level 4)