CEL MeshConnect B1010SP0-EVB-1 Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Материнская плата CEL MeshConnect B1010SP0-EVB-1. CEL MeshConnect B1010SP0-EVB-1 18 страниц. Bluetooth smart evaluation board

Печатать страницу

Compile the Heart Rate application by clicking on Build in the SDK menu bar. Select Build Active Project or press F7

shortcut key. This will build all of the files included in the active project in the current workspace using the selected

configuration into an application image for the Target board.

The build is incremental, so the minimum set of builds are performed in order to reflect changes to source files and

configurations. The Target board must remain connected during compilation.

10. Download the application to the hardware by selecting Run from the Debug menu or press the F5 shortcut key. The Heart

Rate application will now be running on the hardware.

Note that it will stop advertising after a few minutes so will not be visible to any searching phones. To re-enable

advertisements, the button can be connected to PIO11 with a jumper (not supplied) or the eval board can be power cycled.

For more information on the heart rate application, see the Heart Rate Sensor Application Note installed with the SDK. If the

default installation path was chosen, this will be located at C:\CSR_uEnergy_SDK-2.4.5.13\apps\hr_sensor\ CS-227117-

AN_CSRuEnergyHeartRateSensorApplicationNote.pdf

USING B1010SP0-EVB-1 UART DEBUG PORT

The B1010SP0-EVB-1 does not include a 3.3V level shifter required to connect to a computer's USB or RS232 interface.

CEL recommends purchasing an external 3.3V to USB level shifter.

For more information about debugging please see the debug module of the xIDE. It's located under the Navigator window by

selecting Help Documents -> Firmware Library, select the Modules tab and scroll to the bottom and select the Debug module.

The Debug module contains a number of functions to allow an application to send basic text strings across the UART, primarily

for sending debugging messages to a serial terminal.

This document is subject to change without notice.

Document No: 0019-02-08-01-000 (Issue B)

Date Published: September 9, 2015

B1010SP0-EVB-1 Evaluation Board User Guide

Figure 17 - Successfully Built Project